![]() |
|
![]() |
#1 |
Junior Member
![]() Join Date: Jun 2010
Posts: 18
|
![]()
I replaced my clutch disk, and throw out bearing about 5 months ago. For the past couple months after the car heats up, it sometimes shakes as you go to start out in first gear. After you start you do not have any issue driving or switching gears, just starting from a dead stop. And It does not always do it. It is a strong shutter. Any ideas
|
![]() |
![]() |
SaturnFans.com Sponsored Links |
![]() |
#2 |
Master Member
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Join Date: Oct 2005
Location: North of North of Toronto, Northern Ontario, Canada
Posts: 3,074
1999 SL2
2001 SL1
|
![]()
Did this start around the time you started using A/C (assuming your car is equipped)? Could you be feeling the lost power being directed to run your A/C? Just a thought.
...
1999 SL2 MT (311,300 km @ 01/2023) 2012 Ford Focus SEL HB MT 2011 Suburban LT Past Saturns 2001 SL1 MT (438,500 km 11y) 1993 SW2 AT (10y) 2001 LW200 MT (3.5y) 1992 SL2 MT (5y) :canada: |
![]() |
![]() |
![]() |
#3 |
Master Member
![]() ![]() ![]() ![]() ![]() ![]() Join Date: Feb 2011
Location: Texas
Posts: 2,177
2002 SC1
|
![]()
What is the condition of the top engine mount? A collapsed one can let the engine jiggle.
...
BV22 2002 SC1 5M RIP Sept 1 2018 315,344 miles |
![]() |
![]() |
![]() |
#4 |
Advanced Member
![]() Join Date: Jul 2011
Location: upstate NY
Posts: 633
1996 SL2
|
![]()
transmission mount should be checked as well
...
96 sl2 stage 1 midpenn cams,91/92 header,2.25 ss exhaust, ported and polished head, groundpounder, sda bones, pimped tranny mount, .40 o/s pistons, .25 u/s rods, .25 u/s crank,19mm progress swaybar |
![]() |
![]() |
![]() |
#5 |
Junior Member
![]() Join Date: Jun 2010
Posts: 18
|
![]()
The engine mounts look good. And it only occurs sometimes. I can't tell if it is coming from the back wheel or the front. Sometimes it really shutters alot.
|
![]() |
![]() |
![]() |
#6 |
Junior Member
![]() Join Date: Jun 2010
Posts: 18
|
![]()
Plus I have noticed when coming to a stop, I can feel a vibration in the brake pedal. But the rotor doesn't look warped at all.
|
![]() |
![]() |
![]() |
#7 |
Super Member
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
Might be the caliper guide pins. Those need to be replaced, too. Use a good, synthetic brake grease (like sil-glyde, which OldNuc recommended). You may need to clean out or replace the rubber boots as well.
...
I'm not worthy to grovel in the shadow of Signmaster's wisdom 11/2016 red 2002 5 spd SC2 151k DD 12/2008 eBay silver 1998 SL2 5 spd 102k, now 201k+ miles |
![]() |
![]() |
![]() |
Bookmarks |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Won't shift out of 3rd gear...manual transmission. | born2b2b | Vue General | 3 | 09-07-2011 02:05 PM |
Transmission starting in too high a gear? | ericbryanwiggin | S-Series Tech | 9 | 06-30-2011 09:45 AM |
Manual Transmission REFUSES TO GET INTO GEAR. HELP!! | Jerz3455 | S-Series Tech | 2 | 10-17-2007 11:35 PM |
Manual transmission - grinding 3rd gear | Vijay SC2 | General Saturn Discussion | 1 | 07-21-2007 08:36 PM |
2001 Saturn L100 2.2L Manual Transmission Headaches | cybercyst | L-Series Tech | 5 | 11-24-2006 09:28 PM |