View Single Post
Old 05-25-2021, 08:35 PM   #4
Ccrussell
Member
Ccrussell has a spectacular aura aboutCcrussell has a spectacular aura aboutCcrussell has a spectacular aura about
 
Join Date: Nov 2014
Location: Nys country
Posts: 268

1999 SL1
1999 SC2
Default Re: Sl1 trans shift trouble after rebuild

Hello,
Ok this is where I am:
I changed transmission oil, as I had overfilled the transmission by approximately 1 quart. Realizing this, I drained the oil ,changed the filter with a WIX ,and refilled the transmission with the correct level of oil. The used oil had sludge in it however the oil was dark red did not smell burnt and had no signs of any metal contamination. I would be ashamed to tell you how many miles it had on it since itís last change
No change in shifting.
Tonight I checked the terminals on the valve body and discovered that terminal F & G which I presume is line pressure is reading at a low 2.1 ohms.
All the rest are reading 5 ohms or greater.
I have a spare used valve body , from Which I will source a coil, change out ASAP and post results.
Feeling pretty confident that this may be the solution.
Ccrussell is offline   Reply With Quote