SaturnFans.com
saturnfans.com - classifieds - forums - webmail


Go Back   SaturnFans.com Forums > Search Forums

Showing results 1 to 25 of 500
Search took 3.82 seconds.
Search: Posts Made By: ssicarman
Forum: S-Series Tech 07-20-2021, 11:07 PM
Replies: 13
Views: 248
Posted By ssicarman
Re: New Timken wheel bearings/hubs have play?

The splines on the axle mesh with the splines in the hub to transmit power to the wheels. The splines do not seat on/against the hub.

The axle nut does clamp the wheel bearing inner and outer...
Forum: Vue General 04-10-2021, 02:57 PM
Replies: 8
Views: 607
Posted By ssicarman
Re: Crank, no start, no codes

Gas station no starts can be caused by over filling the tank and getting liquid fuel into the evap system. Cured by putting the fill nozzle all the way in and not topping the tank when the nozzle...
Forum: S-Series Tech 04-10-2021, 02:54 PM
Replies: 15
Views: 387
Posted By ssicarman
Re: Bleeding Brakes on ABS system: '94 SL2 HCE

When replacing the rear calipers did you let the fluid in the master cylinder run out/dry/no more fluid in the master?
If so I would try pressure bleeding the entire system.

Air in the master...
Forum: S-Series Tech 04-04-2021, 09:22 PM
Replies: 5
Views: 292
Posted By ssicarman
Re: Alternator not charging, reference voltage 11.3

Have you made sure the power out wire from the alternator is is connected to the same point on the starter that the battery wire is connected to?
Check the voltage at the power out of the...
Forum: S-Series Tech 03-04-2021, 08:32 PM
Replies: 11
Views: 396
Posted By ssicarman
Re: MP3 circlip behind seal: right or wrong?

The clip is for setting clearance/bearing preload for the gear shaft. Supposed to be there.
Forum: Vue Tech 01-25-2021, 11:30 PM
Replies: 5
Views: 669
Posted By ssicarman
Re: 2006 Vue Severe Misfire

At 240k miles if the valve clearances have never been adjusted they should be.
Forum: S-Series General 10-23-2020, 11:36 PM
Replies: 10
Views: 411
Posted By ssicarman
Re: PS Evo connector help

Picture of the electrical connector from the first post would help in describing how to disconnect.

Depressurize what? The fuel tank? It is not pressurized.
Forum: S-Series Tech 09-20-2020, 11:33 AM
Replies: 26
Views: 543
Posted By ssicarman
Re: HELP No Spark or Ignition Pulse 1999 Sl2

I would consider the ignition control module over wiring issues.
Forum: Vue Tech 09-02-2020, 10:41 PM
Replies: 4
Views: 473
Posted By ssicarman
Re: 06' VUE V6 Cyl #4 misfire code

Cylinder #4 is the first one (front of engine) on the front bank.

On these Honda V6 engines out of adjustment valves can cause misfires.
Forum: L-Series Tech 07-20-2020, 10:59 PM
Replies: 2
Views: 460
Posted By ssicarman
Re: the old water pump r and r trick on a 2.2 4cyl

You need to use a special tool mounted (and properly torqued) at the front of the engine to hold the chain sprocket in place. If not used then you will have issues with the chain tensioner extending...
Forum: S-Series Tech 07-11-2020, 10:27 PM
Replies: 23
Views: 863
Posted By ssicarman
Re: '98 DOHC Head Gasket Replacment

From poor memory the bracket looks like it could be for power steering pump. Maybe something to do with the intake.
Forum: S-Series Tech 06-24-2020, 10:33 PM
Replies: 6
Views: 462
Posted By ssicarman
Re: Are there any S-Series that have the GM L81 3.0L V6 Engine?

The S-series never had a V-6 from the factory

The Saturn L81 or versions of appeared in the L series, the early VUE's, SAAB 9000 and the Cadillac Catera.
Forum: L-Series Tech 04-30-2020, 12:00 AM
Replies: 68
Views: 2,472
Posted By ssicarman
Re: 2001 Saturn L300 - v6 3.0 Liter - Rear Brake Pad Swap (Special Tool Needed) ?

In your service manual picture the brake bleeder is at the top of the caliper, all three diagrams. One bleeder per caliper. If this is what you removed/opened then you are golden. Just may need to...
Forum: L-Series Tech 04-29-2020, 07:00 PM
Replies: 68
Views: 2,472
Posted By ssicarman
Re: 2001 Saturn L300 - v6 3.0 Liter - Rear Brake Pad Swap (Special Tool Needed) ?

Brake clean will clean the brake fluid off of the rotors.
I have never split the calipers open so I am not sure what seals them. It may be a rubber type seal or metal to metal sealing. For safety...
Forum: L-Series Tech 04-29-2020, 05:12 PM
Replies: 68
Views: 2,472
Posted By ssicarman
Re: 2001 Saturn L300 - v6 3.0 Liter - Rear Brake Pad Swap (Special Tool Needed) ?

To replace the brake pads on the style of caliper in your picture you do not remove the bolts. The bolts hold the caliper together and if you removed/loosened them than you have caused brake fluid to...
Forum: Ion General 04-27-2020, 11:07 PM
Replies: 5
Views: 554
Posted By ssicarman
Re: Smell

Check/replace the cabin filter.
Forum: Vue General 04-26-2020, 02:59 PM
Replies: 2
Views: 413
Posted By ssicarman
Re: Help

Just to be sure....serpentine belt or timing belt?

Unless they really screwed up hard and heavy there would be very few ways to stop the car from starting after a serpentine belt replacement....
Forum: Vue Tech 04-23-2020, 07:18 PM
Replies: 15
Views: 933
Posted By ssicarman
Re: 07 V6 Starter Replacement Troubleshooting

Starters do not have ground wires. They ground through the case of the starter.

The braided wire from the solenoid to the starter motor is on its own. The other large stud is supposed to have the...
Forum: S-Series Tech 04-17-2020, 08:09 PM
Replies: 20
Views: 6,178
Posted By ssicarman
Re: Thin Ground Wire Near Interior Fuse Box Connection!

Two dangling wires that you did not tape off in an area with a multitude of ground points. Now the car won't start and several inop systems.

How did you check the fuses? Did you check all of the...
Forum: S-Series General 03-26-2020, 10:51 AM
Replies: 13
Views: 491
Posted By ssicarman
Re: Please help - need idle pully stuff

If it was only broken off there is usually enough thread left in the cover to put the mount in place and thread the bolt in place to hold things in place.
The original picture shows that there is...
Forum: S-Series General 03-25-2020, 09:24 PM
Replies: 13
Views: 491
Posted By ssicarman
Re: Please help - need idle pully stuff

The idler pulley mount/support is part of the timing chain cover. The condition yours appears to be in...not really there at all, means that you are looking at replacing the timing chain cover.
Forum: Sky Red Line 02-06-2020, 11:54 PM
Replies: 11
Views: 4,414
Posted By ssicarman
Re: Small "horns" under hood by headlamps

Keep in mind that it has been the better part of 12 years since I have worked on a Saturn and the Sky was a very small part of what we worked on at the dealership.
Looking at the white part in...
Forum: Sky Red Line 01-31-2020, 11:30 PM
Replies: 11
Views: 4,414
Posted By ssicarman
Forum: S-Series Tech 11-23-2019, 10:30 PM
Replies: 18
Views: 957
Posted By ssicarman
Re: battery vs. alternator

Pull the covers off of the ends of the battery cables as the corrosion can build under them and not really show.
Forum: L-Series General 11-06-2019, 10:12 PM
Replies: 6
Views: 571
Posted By ssicarman
Re: 2000 L 5 spd clutch issue

You may want to get a different mechanic. Self adjusting hydraulic system. A quick visual inspection would show hydraulic lines instead of mechanical linkages.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 04:37 AM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.
SaturnFans.com. The Saturn Enthusiasts Site.