SaturnFans.com
saturnfans.com - classifieds - forums - webmail


Go Back   SaturnFans.com Forums > Search Forums

Showing results 1 to 25 of 500
Search took 5.54 seconds.
Search: Posts Made By: bluesl2
Forum: S-Series General 07-17-2021, 10:51 AM
Replies: 2
Views: 161
Posted By bluesl2
Re: 2001 Saturn SC2 Hard Shifting

You may have to do a crank relearn. Start the engine from a cold start, let it run until the service wrench light starts to flash. Raise the engine rpm up to 3000 and hold there until the light quits...
Forum: S-Series Tech 07-10-2021, 10:25 AM
Replies: 15
Views: 428
Posted By bluesl2
Re: 2000 SW2 p0336; rough idle/wont rev/frontfire

You say you swapped the PCM so it's a used one from another vehicle or a brand new one? It may need a crank relearn done. If the PCM is used, you should do a relearn because that PCM has learned the...
Forum: S-Series Tech 06-30-2021, 05:59 PM
Replies: 9
Views: 252
Posted By bluesl2
Re: Stumped with PO327

I heard back in the day the torque specification on the knock sensor is critical. Don't know if that's the problem or not but may be worth checking.
Forum: S-Series Tech 06-27-2021, 11:49 AM
Replies: 5
Views: 172
Posted By bluesl2
Re: Grinding into 4th gear

More than likely you have a bad blocker ring next to the fourth gear synchronizer. It has fiber material on it like the clutch plates in the auto transaxles. It's rare they get burnt and go bad but...
Forum: S-Series Tech 06-12-2021, 09:56 PM
Replies: 5
Views: 249
Posted By bluesl2
Re: 1999 fails smog test for first time no clues as to why

There is a possibility the intake gasket might be bad. Spray some carb cleaner by the #1 intake port where it meets the head and see what happens.
Forum: S-Series Tech 05-25-2021, 10:10 PM
Replies: 11
Views: 418
Posted By bluesl2
Re: Sl1 trans shift trouble after rebuild

Line pressure solenoids on the later years of the S-series were kind of problematic. That resistance reading of 2.1 ohms is enough to make a difference in shifting. I bet changing that fixes it.
Forum: S-Series Tech 05-11-2021, 12:42 AM
Replies: 20
Views: 511
Posted By bluesl2
Re: P0733 2002 sl2

The later years of the S-series had a few issues with the main line pressure solenoid as well. Usually it would make the transaxle shift hard. If you don't see any issues with fuses it would be worth...
Forum: Vue Tech 05-11-2021, 12:24 AM
Replies: 2
Views: 289
Posted By bluesl2
Re: LF Humming Noise 07 Vue

It could be the right front. The Vue's tend to eat wheel bearings.
Forum: S-Series General 03-26-2021, 05:40 PM
Replies: 15
Views: 589
Posted By bluesl2
Re: Saturn jerks

Get the exhaust checked for excessive back pressure. Converter may be plugged or partially plugged.
Forum: S-Series General 03-23-2021, 01:01 PM
Replies: 4
Views: 243
Posted By bluesl2
Re: Is 2001 SL1 chip reprogramming possible?

If you have a hesitation then try checking some things over first. Plugs or plug wires have any issues, wide gap, high resistance or open plug wire? Sticky EGR valve? Possible exhaust restriction?...
Forum: Ion Tech 03-15-2021, 06:11 PM
Replies: 7
Views: 767
Posted By bluesl2
Re: 2004 Saturn Ion 2.2 constant p0442 code

After my post above I see you say they did do smoke tests, sorry about that. Maybe a small leak out the gas tank seal where the fuel pump seals?
Forum: Ion Tech 03-14-2021, 10:13 PM
Replies: 7
Views: 767
Posted By bluesl2
Re: 2004 Saturn Ion 2.2 constant p0442 code

Did any of those repair shops do a smoke test?
Forum: S-Series Tech 03-05-2021, 05:24 PM
Replies: 32
Views: 1,079
Posted By bluesl2
Re: Death wobble at 40 mph and up

Take your front brake calipers off, see if you can push the piston in. I have seen this on an S-series before when the caliper stuck. Are the calipers original to the car do you know?
Forum: S-Series Tech 02-26-2021, 11:55 AM
Replies: 18
Views: 552
Posted By bluesl2
Re: Power loss under load at speed. 0401 code after new EGR.

My bet is on the converter being plugged or there could be a chunk of the platinum broke inside of it bouncing around and intermittently getting stuck causing excessive back pressure. With 300k...
Forum: S-Series General 02-25-2021, 12:09 PM
Replies: 2
Views: 188
Posted By bluesl2
Re: crack on engine block just below valve cover gasket

It appears to be the cylinder head leaking. I have seen a few of the dohc heads crack there. You can try epoxy if you want, but I would replace the head for better long term results. Try cleaning...
Forum: L-Series Tech 02-23-2021, 01:02 AM
Replies: 13
Views: 408
Posted By bluesl2
Re: '03 L200 tranni surge issue...

This is just a thought to throw out to you. I have seen before when the catalytic converter starts to plug and can make the transaxle shift weird like that. Usually it's worse under moderate to heavy...
Forum: Vue Tech 02-21-2021, 11:39 PM
Replies: 7
Views: 761
Posted By bluesl2
Re: 04 Saturn Vue MT speed dependent hum- wheel bearing done

It's most likely the one wheel bearing you have not replaced. The fact you said the noise changes when loaded then unloaded speaks volumes as to it being a wheel bearing. You have probably noticed,...
Forum: S-Series Tech 02-13-2021, 12:43 AM
Replies: 28
Views: 663
Posted By bluesl2
Re: 1997 SW2 P0336 misfire with details

Back in the day, another dealer who was working on a 96 SL1 brought it to us after they couldn't figure it out. They had put a used PCM in the car and cylinders 2 and 3 were about flat dead when...
Forum: S-Series General 02-07-2021, 01:44 AM
Replies: 7
Views: 319
Posted By bluesl2
Re: Cabin lights and headlights flickering/diming over 2k rpm

Only happens at high rpm remember, above 2,000.
Forum: S-Series General 02-04-2021, 10:18 PM
Replies: 7
Views: 319
Posted By bluesl2
Re: Cabin lights and headlights flickering/diming over 2k rpm

Check your belt tensioner, it may be getting weak or it may be stuck, either way the belt could be loose causing it to slip.
Forum: Vue General 02-02-2021, 12:23 AM
Replies: 4
Views: 527
Posted By bluesl2
Re: New ignition key cylinder and housing -- now '03 Vue won't start

30 minute relearn is what it's called. That's what the do it yourselfers are relegated to because they can't do the 10 minute one without the software.
Forum: Vue Tech 01-29-2021, 12:49 AM
Replies: 3
Views: 579
Posted By bluesl2
Re: Should I get my valves adjusted

It's actually recommended at 100k, so yes it would be worth it. It would be a good time to change the plugs and make sure no oil leaks are present from the camshaft covers.
Forum: S-Series Tech 12-28-2020, 12:36 AM
Replies: 7
Views: 266
Posted By bluesl2
Re: 4 Codes and bad smells where to go from here

If you go to a muffler shop be sure to have them check for back pressure in the exhaust. Does the car have any power loss issues?
Forum: S-Series General 12-18-2020, 01:04 AM
Replies: 8
Views: 399
Posted By bluesl2
Re: 3800mile 100% windtunnel '96 SL2

That's a neat story. Those Zexel compressors were very dependable. I don't think I ever changed one of those on an S-series, unless the number of ones I changed were so low I don't remember, LOL.
Forum: S-Series Tech 12-03-2020, 12:25 AM
Replies: 6
Views: 332
Posted By bluesl2
Re: Stall or near stall on deceleration

Check for vacuum leaks. May or may not be related to po442 code.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 04:05 PM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.
SaturnFans.com. The Saturn Enthusiasts Site.