|07-23-2010, 11:56 PM||#1|
Join Date: Dec 2005
Location: Brookline, MA
removing 95 SL2 trim between front and rear door windows?
I'm repainting my car and this piece would be easier to paint off than on the car (automatic car wash ruined the finish on it). There are two push pins that hold the bottom and it seems to hook under the roof at the top, but after removing the two pins at the bottom, it still doesn't want to come off by pushing down, up, or pulling it out.. Is it glued to the car or held on by something from the inside? How can I get it off without damaging it?
It's a '95 SL2 (sedan): Gen 1 exterior, Gen 2 interior. I'm talking about the black plastic trim that fills the area between the front and rear door windows (extending from the bottom of the window to the roof).
High compression build: .033" shaved/ported head, flat-faced valves; gen3 rods, pistons, tie-plate; OE header, custom CAI, SDA street cams with adjustable sprockets, WBO2, SAFCII, LSD. ASE A1-A8+L1
|SaturnFans.com Sponsored Links|
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Removing exterior door b-pillar trim....||bromeoSC2||S-Series Tech||5||06-08-2010 05:03 AM|
|Removing the door trim panels||Dan76||S-Series General||5||04-08-2007 05:27 AM|
|Removing Door Trim on '97 SL2||djmikeyz28||S-Series General||4||01-07-2006 04:38 PM|
|Removing Inner Door Trim||androol||S-Series General||1||11-17-2005 11:20 PM|
|Need help removing the trim around front courtesy lights.||fgwinn||Vue General||4||01-24-2004 11:51 PM|