|10-15-2018, 06:50 PM||#1|
Join Date: Aug 2009
Location: San Francisco, CA
2008 Astra XR
Techflex F6 Self-Wrapping Braided Sleeving
I'm about to repair some of the disintegrating wiring covers under the hood. I was about to order some nylon split wire looms, but ran across Self-wrapping Split Braided Sleeving.
Material is PET, melting point is around 476°F.
Has anybody tried this stuff? You think it'll work as good/better than the traditional plasticky split loom stuff at protecting wiring?
The one in worst shape is the camshaft position sensor harness, which dangles down to the intake manifold. Keep getting the dreaded P0365 code and wondering if the exposed wire around that hot zone might be contributing to that. Oil is clean, next step is to replace the sensors, but wanted to take care of the wiring issue first.
Then took a look around under the hood and found a few more looms that were falling apart, so decided to just fix them all.
As always, thank you so much for any help/advice.
Astra XR5, Star Silver, Sunroof, Auto Trans, Sport Handling Pkg, Advanced Audio Pkg, Heated Seats
|SaturnFans.com Sponsored Links|
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Vinyl wrapping my SL2||DrvLikHell||S-Series General||28||06-16-2019 09:20 AM|
|Wrapping up clutch and tranny project||MikeNW||S-Series General||11||01-06-2018 11:53 AM|
|Vinyl wrapping?||robert16||S-Series Mods||24||01-18-2012 11:22 PM|
|ECOTEC Re-Sleeving||WopOnTour||Miscellaneous Tech||9||04-08-2004 01:25 AM|
|Wrapping header/manifold?||Twin_Cam||S-Series Mods||5||04-03-2003 01:37 PM|