|
|
11-09-2005, 02:17 PM
|
#1 | ||||
|
New Member
 
Join Date: Nov 2005
Posts: 3
2003 ION-3 Quad Coupe
|
Finding the antenna lead in Ion 2003 QC
Hey all,
I've got a Delphi SkyFi2 XM receiver and the direct wire kit that connects it to the FM antenna lead for better signal quality. Call me stupid, but I can't figure out how to get to the antenna lead in my 2003 QC, and I haven't been able to find any diagrams or anything online. Any suggestions? That is all.
|
||||
|
| SaturnFans.com Sponsored Links |
|
11-09-2005, 02:27 PM
|
#2 | ||||
|
Super Member
 
|
Re: Finding the antenna lead in Ion 2003 QC
Its not on the back of the radio?
|
||||
|
|
|
11-09-2005, 02:36 PM
|
#3 | ||||
|
New Member
Join Date: Nov 2005
Posts: 3
2003 ION-3 Quad Coupe
|
Re: Finding the antenna lead in Ion 2003 QC
Um, my bad, I should've phrased the question differently. It's not that I don't know where the antenna lead is, but that I can't figure out how to get to it. I gather I need to disassemble part of the dash since my deck is rear-installed, but I've only found two screws (near the floor to either side of the center console) and they didn't help at all...
So basically, I need a diagram or walkthrough or getting started guide or *something* to help me get the dash apart so I can get to the lead. That is all.
|
||||
|
|
|
11-09-2005, 03:04 PM
|
#4 | ||||
|
Super Member
|
Re: Finding the antenna lead in Ion 2003 QC
If no one comes up with a how-to by tonight, I'll try and remember and look it up in the FSM.
|
||||
|
|
|
11-09-2005, 11:41 PM
|
#5 | ||||
|
Super Member
|
Re: Finding the antenna lead in Ion 2003 QC
Ok, looked it up in the FSM. It looks very easy.
1. Pull out the accessory trim plate in order to release the retaining fasteners. (In english, unsnap the silver trim panel that surrounds the radio and HVAC controls.) 2. Disconnect the accessory trim plate electrical connections. (disconnect the electrical connector to the two switches) 3. Remove the two screws from the radio and pull the radio out 4. Disconnect the radio electrical connectors and remove the radio.
|
||||
|
|
|
11-09-2005, 11:44 PM
|
#6 | ||||
|
New Member
Join Date: Nov 2005
Posts: 3
2003 ION-3 Quad Coupe
|
Re: Finding the antenna lead in Ion 2003 QC
Sounds good, I'll try this tomorrow morning. Thanks much!
That is all.
|
||||
|
|
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Antenna for 2003 L200 | osborn4 | L-Series Tech | 3 | 01-01-2010 09:08 PM |
| Finding Switched Power In An '06 Ion 2 | custom1106 | Ion Tech | 3 | 05-18-2006 08:37 PM |
| Vue Antenna lead Location | miadlor | Vue General | 2 | 02-14-2005 09:42 PM |
| Finding the ION I want | davidsky | Ion General | 7 | 06-16-2004 09:13 PM |
| ION antenna? | Rapture | Ion General | 6 | 09-20-2002 04:56 PM |
All times are GMT -4. The time now is 11:03 PM.