|03-07-2018, 08:07 PM||#1|
Join Date: Apr 2006
Location: Orlando, FL
‘00 SL1 hazards/signals all OK until headlights on, then nothing!
Searched the tech threads and haven’t seen this one.
Recently replaced the flasher bulbs (3157) with LED bulbs. The side marker flasher mod was done years ago.
Now of course I get the hyper flash with the hazards and turn signals. I like/need the hyper flash in the road warrior Orlando street environment so I have no problem with that.
I also recently noticed one license plate light was out when I replaced them with LED. After a little sleuthing with the multimeter, found a bad ground wire to one light bulb mount. I connected the ground wire from the working bulb mount to the inop mount and works fine now.
So immediately after the signal bulbs were installed and op checked good signaling and with hazards on, everything STOPS working (no relay clicking no flasher illumination at all) ONLY when the headlights are turned on.
Turn them off and everything works again!
Help our Saturns' resale value, get a gas mileage log and record yours online at:
'00 SL1, 5Spd, 184k 38mpg combined
|SaturnFans.com Sponsored Links|
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Turn signals & hazards intermittent in 91 SL2||Cartell||S-Series General||2||09-19-2011 01:14 AM|
|Turn signals don't work, hazards do||a7x_audiojunkie||S-Series Tech||2||06-03-2009 05:03 PM|
|No signals or hazards but fuses & flasher fine||number9||S-Series Tech||10||11-26-2008 07:48 PM|
|94 SL2, hazards disable turn signals||My Range||S-Series General||3||11-21-2005 06:53 PM|
|turn signals and hazards just stopped working||renadena||S-Series General||6||05-14-2005 04:14 PM|