View Single Post
Old 08-23-2012, 02:34 PM   #7
randers
New Member
randers is on a distinguished road
 
Join Date: Aug 2012
Posts: 7
Default Re: 94 Saturn Sedan Auto Trans-won't go in gear

New development. Just got the car up on jackstands and pulled tires. The new passenger side axle shaft that I recently installed has come off of the mid shaft. I'm assuming this is something I overlooked during assembly but the car ran fine and I had almost 1000 miles on it since the installation. I also replaced the outer tie rod ends and the balljoint assembly during this process. I made certain everything was torqued to spec. Other than the shaft being disengaged from the splines I can't see any other issues. I haven't pulled it apart yet to see if there is any issue with the shaft itself. When I put it back together the manual tells me to push the shaft in until I here it click when it engages the clip on the midshaft. Can anyone think of another issue I might need to look into while I have this apart?

REWARD EXCELLENCE!

Add to randers's Reputation
Rate the quality of this post and help randers reputation points. Click the reputation button near the bottom left corner of this message box. Thank you!
randers is offline   Reply With Quote