View Single Post
Old 08-16-2018, 10:22 PM   #2
Zeebins
Member
Zeebins is a jewel in the roughZeebins is a jewel in the roughZeebins is a jewel in the roughZeebins is a jewel in the rough
 
Zeebins's Avatar
 
Join Date: Jun 2017
Location: Massachusetts
Posts: 431
 

1997 SL2
Default Re: 2nd Gen Interior Center Console Handle 3D Print Model

I 3D printed a coin holder a while back since I didn't have one and thought it would be cool to make. It turned out pretty well, I made the hooks a little to long but i just fixed it with velcro, didn't really feel like printing another one. Problem was though that I made it when it was still cold outside. Once the weather warmed up and the car started to get 90+ degrees inside, the plastic didn't hold up to well. I'm pretty sure it only warped like that was because of the weight from the coins dragging it down due to the plastic being soft from the heat. It probably be fine today if i never put any coins in it but then what would be the point of making it, lol

Hopefully your thing holds up better than my thing did, it probably will though sense its not really holding any weight.

http://www.saturnfans.com/forums/sho...59#post2265759
http://www.saturnfans.com/forums/sho...62#post2271362
Attached Images
File Type: jpg IMG_3139.jpg (46.2 KB, 16 views)
File Type: jpg IMG_3740.jpg (28.6 KB, 15 views)

...
"Tupperware on wheels"
1997 SL2, 109K miles

REWARD EXCELLENCE!

Add to Zeebins's Reputation
Rate the quality of this post and help Zeebins reputation points. Click the reputation button near the bottom left corner of this message box. Thank you!
Zeebins is offline   Reply With Quote