View Single Post
Old 09-10-2019, 08:17 PM   #4
fdryer
Super Member
fdryer has a reputation beyond reputefdryer has a reputation beyond reputefdryer has a reputation beyond reputefdryer has a reputation beyond reputefdryer has a reputation beyond reputefdryer has a reputation beyond reputefdryer has a reputation beyond reputefdryer has a reputation beyond reputefdryer has a reputation beyond reputefdryer has a reputation beyond reputefdryer has a reputation beyond repute
 
fdryer's Avatar
 
Join Date: Jan 2006
Location: NYC
Posts: 43,006
 

2003 L-Series 3.0L Sedan
Default Re: Engine/trans mounts

I have rust everywhere (NYC salted roads). I wire brush to knock off surface rust, chisel built up corrosion then paint with undercoating from a spray can. It helps. The trick is keeping after corrosion as it pops up and treating it before winter in the rust belt states. Below is a file describing the right engine mount examination. Images are after securing the engine with GMs support cradle above the engine then removing the engine mount.
Attached Images
File Type: gif TifToGif.gif (40.3 KB, 7 views)
File Type: gif TifToGif (1).gif (15.0 KB, 6 views)
Attached Files
File Type: pdf Service Information.pdf (90.8 KB, 4 views)

Last edited by fdryer; 09-10-2019 at 08:24 PM..

REWARD EXCELLENCE!

Add to fdryer's Reputation
Rate the quality of this post and help fdryer reputation points. Click the reputation button near the bottom left corner of this message box. Thank you!
fdryer is offline   Reply With Quote