View Single Post
Old 02-16-2017, 12:47 PM   #1
Jonasan308
Advanced Member
Jonasan308 is a glorious beacon of lightJonasan308 is a glorious beacon of lightJonasan308 is a glorious beacon of lightJonasan308 is a glorious beacon of lightJonasan308 is a glorious beacon of light
 
Jonasan308's Avatar
 
Join Date: May 2016
Location: Northeast ohio
Posts: 617
 

1999 SC1
Default Saturn S-series inner door panel and rods

So at some point in time, i will need to dissect my inner door panels. I have a power window on my left side that makes a grinding noise when i use the switch and only rolls down a little. And the keyhole locks on the outside dont quite work right. I can unlock my car, but not without tripping the alarm system and causing my car to get stuck. The lock doesnt feel right when you stick in the key. It may need some lubrication. Or some going over. I have a keyless entry so this isnt a real problem but it makes me nervous to think what would happen if i lost it or something. So, when we arent getting buried in snow, i would like to attempt to get at these issues.

Heres the issue. The door rods. I couldnt figure out how to get them into place properly so i could get the panel back together with all the lock connectors and stuff. So. Anyone have a guide to do that? With pictures?

REWARD EXCELLENCE!

Add to Jonasan308's Reputation
Rate the quality of this post and help Jonasan308 reputation points. Click the reputation button near the bottom left corner of this message box. Thank you!
Jonasan308 is offline   Reply With Quote
SaturnFans.com Sponsored Links