View Single Post
Old 09-20-2016, 06:54 PM   #7
billysvue
Master Member
billysvue is a jewel in the roughbillysvue is a jewel in the roughbillysvue is a jewel in the rough
 
Join Date: Aug 2012
Location: san diego
Posts: 4,355

2005 VUE 2.2L
Default Re: high idle RPM after 2.4 manifold swap

Quote:
Originally Posted by kevin.st56 View Post
Took the manifold off, and i found a crack on the manifold body before it loops around to the head..
YOur new mani has a crack? Jeez, you think you were too rough on in during install or just didn't inspect it well, prior to?..

THere are plastic compatible epox's for just a few bucks at WAlly WOrld, Home Cheepo , Blowes etc...... Dont rush the prep( acetone should clean well) and might want to crosshatch area gently with a razor knife to add some 'tooth' to the surface prior to ...

...
'05 ,2.2L, FWD,5-speed stick with transaxle death rattle is history,,,
'17 Suby Forester

245216 mi. VUe is off to the dealer auction
I'm a secondhand vegetarian.
Cows eat grass, I eat cows.

REWARD EXCELLENCE!

Add to billysvue's Reputation
Rate the quality of this post and help billysvue reputation points. Click the reputation button near the bottom left corner of this message box. Thank you!
billysvue is offline   Reply With Quote