SaturnFans.com
saturnfans.com - classifieds - forums - webmail


Go Back   SaturnFans.com Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.16 seconds.
Search: Posts Made By: bern
Forum: Ion Tech 05-26-2020, 03:52 PM
Replies: 2
Views: 71
Posted By bern
Re: Ignition issue

Remove the small plug / cover in the bottom of thee steering column, inside the hole push the solenoid to the left and rotate the key back to lock.
Note: a bad switch in the floor shifter is the...
Forum: Vue Tech 05-25-2020, 08:15 PM
Replies: 1
Views: 84
Posted By bern
Re: 2004 vue 2.2 p0480

The DTC P0480 is for the ECM detects an open on the low speed cooling fan relay control circuit. I suspect the ECM is switching on the high speed fan because the low speed control circuit has an...
Forum: Vue Tech 05-25-2020, 07:38 PM
Replies: 7
Views: 5,845
Posted By bern
Re: 2003 Vue Door Lock Problem

This is a commend problem. The door latches when starting to fail may lock or unlock the first time (cold) the fob button or door panel button is pressed. But operating the door locks (latches) a few...
Forum: Ion Tech 05-13-2020, 09:28 PM
Replies: 2
Views: 146
Posted By bern
Re: Saturn Ion 2.2L transmission swap!

This small of a gear change will not likely make a difference. Change tire size or replacing the engine with a 2.4L (If smog testing is not required) will be more noticeable change.
Forum: Vue Tech 05-13-2020, 09:16 PM
Replies: 4
Views: 208
Posted By bern
Re: Leaky oil cooler line on new radiator

If the part that is leaking was already assembled to the new radiator then take it back.
Forum: Vue Tech 05-02-2020, 06:21 PM
Replies: 6
Views: 355
Posted By bern
Forum: Vue Tech 04-11-2020, 06:57 PM
Replies: 2
Views: 526
Posted By bern
Re: Calibration after transmission swap? 2008 Vue

If a NEW TCM has been installed into the vehicle, the NEW module needs to be reprogrammed. Refer to Service Programming System (SPS).

Important: The Reset Transmission Adapts procedure must be...
Forum: Vue Tech 04-04-2020, 02:06 PM
Replies: 12
Views: 631
Posted By bern
Re: ABS&TC lights on my dash...pplease help

If the vehicle has an ABS light then it also has ABS brakes (4 wheel) Towing a Vue with 2 wheels turning and 2 wheels not turning will set a DTC. Make a note of each code set. Then just clear all...
Forum: Ion General 04-01-2020, 12:07 AM
Replies: 6
Views: 267
Posted By bern
Re: Ion Window Won't Go Up

harness in the driver's door jam
Forum: Ion Tech 04-01-2020, 12:02 AM
Replies: 5
Views: 289
Posted By bern
Re: What transmission fluid in a 2007 Ion sedan?

ACDelco Dexron VI about 7 quarts
Forum: Ion Tech 03-04-2020, 01:41 AM
Replies: 1
Views: 1,287
Posted By bern
Re: Ion Turns left when braking, Right on Accelerating

Check the right side brake caliper for a frozen piston and / or guides
Forum: Ion Tech 01-19-2020, 08:58 PM
Replies: 13
Views: 493
Posted By bern
Re: 2005 Ion limp mode and then some!

With the car back into The Body Shop. Your son in law should remove the body control module and inside fuse box combo that is located under the instrument panel in the forward part of the center...
Forum: 2008 Vue 01-18-2020, 12:01 AM
Replies: 3
Views: 718
Posted By bern
Re: 08 Vue 3.6L massive oil leak

The PCV office in the right (rear) valve cover is likely plugged. this may crank case pressure to push oil back wards out the fresh air side of the pcv system and / or any seal or gasket see:
TSB...
Forum: Vue Tech 12-28-2019, 02:57 PM
Replies: 11
Views: 680
Posted By bern
Re: V6 Rattling noise - gone when warm

The 3.5 liter V-6 Engine dose not have Hydraulic lifters. It has solid lifters and if one or more were loose they would make noise all of the time and would not change with engine temperature...
Forum: Vue Tech 12-28-2019, 02:37 PM
Replies: 3
Views: 374
Posted By bern
Re: P0171 System Too Lean Bank 1

The P0171 DTC is usually set when their is a vacuum leak. You can spray Brake cleaner or carburetor cleaner Around the intake manifold, the brake booster hose, the purge valve hose. test the purge...
Forum: Ion Tech 12-17-2019, 11:47 PM
Replies: 5
Views: 381
Posted By bern
Re: No heat please help

maybe you have a blown head gasket. pressure test the cooling system with the spark plugs out.
Forum: Vue Tech 12-17-2019, 11:27 PM
Replies: 4
Views: 469
Posted By bern
Re: Auto fluid level?

That transmission should have a dipstick behind the engine mount.
Forum: Vue Tech 12-17-2019, 11:22 PM
Replies: 3
Views: 315
Posted By bern
Re: 2008 Vue XE ABS Control Module

under the master cylinder area. Why do you want to replace it? The EBCM will need to be programmed to.
Forum: Vue Green Line 10-07-2019, 12:09 AM
Replies: 5
Views: 1,102
Posted By bern
Re: 2007 Saturn Vue Green Line (Hybrid) 12V battery not charging redux. Also, cut wi

The cut wires are from a recall back in 2008. The connector and harness that is connected to the starter generator is a replacement for the cut off wires during the recall. The belt is ok? You need...
Forum: Ion Tech 09-08-2019, 02:08 PM
Replies: 24
Views: 1,203
Posted By bern
Re: Sudden Leak

In the video it looks like your Ion has a manual transmission, does it? The oil drips on the trans maybe coming from the axle shaft seals and oil migrating forward to the lowest point.
The mess on...
Forum: Ion Tech 09-08-2019, 01:27 PM
Replies: 3
Views: 595
Posted By bern
Re: 2004 Saturn ion 2.2 manual transmission little to no clutch pedal

If the is still low then the clutch system still may have air in it.
Note most technicians don't know how to bleed these systems. did you share the information above with the technician (not the...
Forum: Vue General 09-02-2019, 03:51 PM
Replies: 2
Views: 233
Posted By bern
Re: Clicking/tapping by brakes

Th Ions had this problem on the right rear only. If the drum is machined too course. the cut in the drum would pull the shoes away from the backing plate the pop back in repeating. Check for too...
Forum: Ion Tech 08-18-2019, 07:14 PM
Replies: 3
Views: 595
Posted By bern
Re: 2004 Saturn ion 2.2 manual transmission little to no clutch pedal

You need to vacuum bleed the clutch. The vacuum needs to be pulled from the reservoir, leave bleeder screw closed. attach vacuum tool in way to the top of the reservoir that is air tight. pull the...
Forum: 2008 Vue 08-11-2019, 05:41 PM
Replies: 2
Views: 466
Posted By bern
Re: 2.4L Ecotec: Same camshaft position sensors?

it is not likely the sensors that are bad, but more likely the actuator control solenoids that bad. test for high resistance hot. check oil level. ACDELCO 12679100 and 12679099
Forum: Vue Tech 08-03-2019, 09:48 PM
Replies: 4
Views: 341
Posted By bern
Re: Cross bar loose on 2009 Vue.....

looks like an old window manual crank handle spline
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 08:59 AM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
SaturnFans.com. The Saturn Enthusiasts Site.