SaturnFans.com
saturnfans.com - classifieds - forums


Go Back   SaturnFans.com Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.38 seconds.
Search: Posts Made By: td1238
Forum: S-Series Tech 05-30-2022, 06:46 PM
Replies: 7
Views: 201
Posted By td1238
Re: Steering Axis/King Pin Inclination

Moving the top strut mount affects SAI and camber together. Moving at the knuckle junction only affects
camber.
If your hip and foot are inline at a certain angle with regard to the floor, and a...
Forum: S-Series Tech 05-30-2022, 12:16 PM
Replies: 7
Views: 201
Posted By td1238
Re: Steering Axis/King Pin Inclination

I'm just curious. Not super important. I've already reduced mine. Much better. Camber goes positive in both directions with original SAI. Reducing SAI at the strut mount and changing camber at the...
Forum: S-Series Tech 05-29-2022, 10:58 PM
Replies: 7
Views: 201
Posted By td1238
Re: Steering Axis/King Pin Inclination

This doesn't have SAI, but is good info. Thanks
Forum: S-Series Tech 05-28-2022, 05:13 PM
Replies: 21
Views: 874
Posted By td1238
Re: 2001 SL1 stalls slowing at a light, restarts again later

Shutting off when hot can be the crank position sensor. Should measure 900 ohms.
My car would stall when I'd hit the brakes back when I had tungsten lamps due to a corroded battery cable connection...
Forum: S-Series Tech 05-28-2022, 05:08 PM
Replies: 7
Views: 201
Posted By td1238
Steering Axis/King Pin Inclination

Anyone know what the stock SAI/KPI is on an S series?
Forum: S-Series Tech 05-27-2021, 01:28 PM
Replies: 7
Views: 381
Posted By td1238
Re: computer for 97 SL1

Usually plenty of good used ones on eBay.
Forum: S-Series Tech 05-27-2021, 08:35 AM
Replies: 8
Views: 404
Posted By td1238
Re: Sway Bar Bushings

I live in Milwaukee, Wisconsin, and both my car and a friend's have seen plenty of salt. However, with soaking the nuts the night before, and then again before bolt removal, I've had no issues. Never...
Forum: S-Series Tech 05-26-2021, 01:29 PM
Replies: 8
Views: 404
Posted By td1238
Re: Sway Bar Bushings

Spray lots of PB blaster at those nuts any way you can. OldNuc used to warn that they'd break loose if rusted too much. That would be a bad day.
Forum: S-Series Tech 05-26-2021, 08:26 AM
Replies: 17
Views: 563
Posted By td1238
Re: Struggling to idle at start when hot

Few other things to consider that have either happened to myself or my friend with the same model Saturn: Try unplugging the EGR valve. If its sensor is sending erroneous data, but isn't enough to...
Forum: S-Series Tech 05-26-2021, 08:14 AM
Replies: 4
Views: 277
Posted By td1238
Re: Alignment For A Smooth Ride

See, what I've read was the opposite, that toe-in caused inner tire wear, and vice versa. With rear-leaning caster, toe-in would cause the inner edges to contact most, but maybe I'm missing...
Forum: S-Series Tech 05-26-2021, 08:09 AM
Replies: 7
Views: 298
Posted By td1238
Re: Blend door motor ??

If a 96 is like a 99, you can also access it through the top by removing the top dash cover. It's still a pita, though. For quite a while I had it removed, and would just reach up from underneath and...
Forum: S-Series Tech 05-25-2021, 11:21 PM
Replies: 4
Views: 277
Posted By td1238
Re: Alignment For A Smooth Ride

Ya, tough to say if they'd do custom settings for you. They always did factory spec for me, and I was always dissatisfied with the ride. Now, I do all of my own alignments. Tedious, but effective. ...
Forum: S-Series Tech 05-25-2021, 08:59 PM
Replies: 19
Views: 802
Posted By td1238
Re: REALLY hard to shift - bad cables? bad hydraulics?

So, 3 things. First, I partially apologize because I did kinda graze this post quickly. This time I re-read it better.

Second, however, what I did see is that it was easy to shift with the engine...
Forum: S-Series Tech 05-25-2021, 07:16 PM
Replies: 19
Views: 802
Posted By td1238
Re: REALLY hard to shift - bad cables? bad hydraulics?

Seems to be a common problem with the Dex 3, if one hoses down the engine. Water gets in and causes poor shifting.
Forum: S-Series Tech 05-25-2021, 05:48 PM
Replies: 19
Views: 802
Posted By td1238
Re: REALLY hard to shift - bad cables? bad hydraulics?

You likely need a new clutch. I replaced mine 2 years ago at 325,000 miles, and wish I had sooner. The diaphragm spring fingers get weak, and don't transfer motion to the diaphragm spring to lift the...
Forum: S-Series Tech 05-25-2021, 05:42 PM
Replies: 11
Views: 11,616
Posted By td1238
Re: How to bleed a sealed clutch hydraulic assembly

I did all sorts of things to my hydraulic system--bleed, replace, even increased the reservoir check valve spring tension. All of this made temporary improvements, and eventually what happened is...
Forum: S-Series Tech 05-25-2021, 05:34 PM
Replies: 7
Views: 298
Posted By td1238
Re: Blend door motor ??

The motors on eBay for Buick Enclave, Chevrolet Malibu, etc., look virtually identical. Inspect well and see if they are. If not identical, perhaps the gear inside is.

On my '99 SL2, the large...
Forum: S-Series Tech 05-25-2021, 05:25 PM
Replies: 4
Views: 277
Posted By td1238
Alignment For A Smooth Ride

Something interesting for you to try: I've read that the factory felt that front toe and camber were best at zero, and I agree with the camber part. Even a half degree in front is enough to make...
Forum: S-Series Tech 11-11-2020, 05:03 PM
Replies: 9
Views: 437
Posted By td1238
Re: Power windows slow?....Try this tip..!

I know that others here have indicated success with petroleum type greases such as litheum, but you really don't want to use a petroleum grease on rubber. It both swells and damages the rubber, and...
Forum: S-Series Tech 11-11-2020, 09:23 AM
Replies: 9
Views: 437
Posted By td1238
Re: Power windows slow?....Try this tip..!

I pour Dot 5 silicone brake fluid down the tracks. I have never used lithium or petroleum type greases because I was unsure as to how they'd affect the rubber. As in your experience, however, the...
Forum: S-Series Tech 09-24-2020, 11:03 PM
Replies: 47
Views: 22,745
Posted By td1238
Re: Piston Ring Cleaning

...There is a way to significantly reduce oil burning, without removing pistons, but it doesn't involve anything mentioned here.
Forum: S-Series Tech 09-23-2020, 08:37 PM
Replies: 9
Views: 537
Posted By td1238
Re: Manual Transmission Shifter Link

I've used the second one with good success. There's also a plastic one in which a metal ring is inserted to keep the fingers expanded. I applied super glue to the ring because it looked like it would...
Forum: S-Series Tech 09-23-2020, 08:32 PM
Replies: 9
Views: 389
Posted By td1238
Re: Idle air control solenoid- part#

Mine started sticking at over 300,000 miles IN Chicago traffic. Idle would hold at 3K, and was not resettable. Cleaning and lubing it didn't fix the problem. Bought one on ebay for $10. Still good. ...
Forum: S-Series Tech 09-23-2020, 08:09 PM
Replies: 0
Views: 219
Posted By td1238
When Your Clutch Won't Release Anymore...

https://www.instagram.com/p/BjTOEPegJoZ/?igshid=vl7epenvnmsz

Example of how the fingers have been bent inward from fatigue. They also likely lost their tension, making them bend more and do less....
Forum: S-Series Tech 09-23-2020, 08:02 PM
Replies: 6
Views: 287
Posted By td1238
Re: Fuse panel issues

Yes, my car has this relay, and doesn't even have an anti-theft system. I could not find this relay on my friend's 2001, which does have an anti-theft system. Worth looking for, though. Good pointer....
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 05:58 PM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.
SaturnFans.com. The Saturn Enthusiasts Site.