SaturnFans.com
saturnfans.com - classifieds - forums - webmail


Go Back   SaturnFans.com Forums > Search Forums

Showing results 1 to 25 of 500
Search took 2.76 seconds.
Search: Posts Made By: Greg1
Forum: S-Series Tech 05-29-2020, 12:45 AM
Replies: 12
Views: 201
Posted By Greg1
Re: 2000 saturn sw2 cooling fan issues

If you have access to a scanner, monitor coolant temperature and see if the fan kicks on at around 221F.
Forum: S-Series Tech 05-24-2020, 12:40 AM
Replies: 8
Views: 261
Posted By Greg1
Re: Need help troubleshooting intermittent hesitation and hard starting

An intermittent crankshaft position sensor will cause starting problems especially when hot.
Forum: S-Series Tech 05-23-2020, 12:35 AM
Replies: 7
Views: 145
Posted By Greg1
Re: Rear hub bolt torque?

My Haynes manual lists the torque as 63 ft-lbs.
Forum: S-Series Tech 04-19-2020, 12:33 AM
Replies: 34
Views: 776
Posted By Greg1
Re: Leaking fuel line at fuel rail?

You probably need to replace the fuel filter assembly which includes the line with the leaking fitting.
Forum: S-Series Tech 04-14-2020, 12:13 AM
Replies: 4
Views: 248
Posted By Greg1
Re: exhaust manifold-to-head studs

I just measured one and I believe they are M8-1.25.
Forum: S-Series Tech 01-25-2020, 01:25 AM
Replies: 2
Views: 508
Posted By Greg1
Re: 2000 sl2 dohc intake manifold

The usual problems with the plastic DOHC manifolds are coolant leaks. It's the SOHC engines that are prone to defective intake manifold gaskets which cause vacuum leaks and associated idle problems....
Forum: S-Series Tech 12-14-2019, 12:52 AM
Replies: 43
Views: 1,252
Posted By Greg1
Re: 1997 SW2 Crank but no start, stuck on wiring.

I've had it happen on my 97 several times and I believe it was the valves not closing all the way. It would resolve itself by letting it sit a while before trying again. I have not experienced it...
Forum: S-Series Tech 10-26-2019, 01:14 AM
Replies: 12
Views: 509
Posted By Greg1
Re: Detonation due to Carbon Buildup

There is a test port for a fuel pressure test gauge under the hood in the fuel line going to the fuel rail. You should be able to borrow one from Autozone or equivalent.
Forum: S-Series Tech 10-12-2019, 01:18 AM
Replies: 3
Views: 227
Posted By Greg1
Re: What's the name ofwater hose behind dr. side intake

I believe that hose is called intake manifold to heater.
Forum: S-Series Tech 09-02-2019, 11:31 PM
Replies: 10
Views: 290
Posted By Greg1
Re: engine swap now missfire

The oil pressure sender.
Forum: S-Series Tech 08-08-2019, 12:19 AM
Replies: 8
Views: 550
Posted By Greg1
Re: Rear Disc Brakes?

I converted my non ABS 97 SW2 to rear discs. It was a bolt on conversion and I did not replace the master cylinder. The emergency brake cables are different with rear discs but I believe the flex...
Forum: S-Series Tech 07-01-2019, 12:15 AM
Replies: 20
Views: 422
Posted By Greg1
Re: My sc2 is overheating.

it's the small one from the intake to the reservoir.
Forum: S-Series Tech 06-05-2019, 12:28 AM
Replies: 3
Views: 192
Posted By Greg1
Re: High Idle 4000 in park

Is the brake booster vacuum line to the back of the intake connected?
Forum: S-Series Tech 01-07-2019, 01:22 AM
Replies: 5
Views: 301
Posted By Greg1
Re: P0327 after intake manifold fix

I believe that goes to the canister purge solenoid.
Forum: S-Series Tech 12-31-2018, 12:46 AM
Replies: 19
Views: 799
Posted By Greg1
Re: Engine swap at 99.9% completion.. then one problem..

The starter is not controlled by the PCM so chances are, your problem is simple. Check to make sure the purple solenoid wire is connected to the starter. If so it should see 12V when the key is...
Forum: S-Series Tech 12-25-2018, 01:01 AM
Replies: 90
Views: 3,594
Posted By Greg1
Re: hard starting 2001 SL1

The CPS is located on the rear of the engine above the starter.
Forum: S-Series Tech 12-01-2018, 02:28 AM
Replies: 7
Views: 515
Posted By Greg1
Re: 2001 Saturn SL2 - P0446 - no fuel pressure

There is not a fuel pressure sensor.
Forum: S-Series Tech 11-10-2018, 02:30 AM
Replies: 12
Views: 824
Posted By Greg1
Re: Torque Specs for Exhaust

It's an E7. It is in a set I got at Harbor Freight.
Forum: S-Series Tech 10-23-2018, 12:16 AM
Replies: 6
Views: 283
Posted By Greg1
Re: Engine swap question

I don't think the DOHC exhaust manifold will line up properly with the SOHC exhaust down pipe.
Forum: S-Series Tech 09-03-2018, 11:39 PM
Replies: 8
Views: 496
Posted By Greg1
Re: Oil coming up to cap during change

That is normal and it is very easy to make a mess when adding oil. The baffle on the underside of the cover is what causes it.
Forum: S-Series Tech 08-29-2018, 12:14 AM
Replies: 9
Views: 402
Posted By Greg1
Re: New used eng high idle

The brake booster vacuum line which connects to the rear of the intake is easy to forget to connect.
Forum: S-Series Tech 08-20-2018, 12:40 AM
Replies: 8
Views: 451
Posted By Greg1
Re: A/C Hose.

There is a short metal line that is part of the dryer that screws to the hard line that goes to the TXV. That line is all metal and not typically replaced so it would have to be a junk yard item....
Forum: S-Series Tech 08-10-2018, 11:49 PM
Replies: 31
Views: 3,753
Posted By Greg1
Forum: S-Series Tech 07-20-2018, 01:02 AM
Replies: 41
Views: 2,341
Posted By Greg1
Re: 2002 SL won't pass smog with OBDII fail

The pre-cat is part of the exhaust manifold. It can be readily unbolted and removed after moving the AC compressor out of the way. If you are just wanting to break out the honeycomb catalyst...
Forum: S-Series Tech 07-08-2018, 11:52 PM
Replies: 33
Views: 1,480
Posted By Greg1
Re: A new twist on an old favorite: Hesitation AFTER replacing ECTS

For what it is worth the dealer here sold them as different parts.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 09:17 PM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
SaturnFans.com. The Saturn Enthusiasts Site.