SaturnFans.com
saturnfans.com - classifieds - forums - webmail


Go Back   SaturnFans.com Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.93 seconds.
Search: Posts Made By: fetchitfido
Forum: S-Series Tech 10-27-2020, 10:28 AM
Replies: 2
Views: 86
Posted By fetchitfido
Re: 95 DOHC tensioner pulley

Depends on what belt you get. The OEM belt length with A/C and PS requires the 100mm pulley, if yours is shorter than OEM then you need the 90mm pulley. Most aftermarket non-OEM style tensioners come...
Forum: S-Series General 10-27-2020, 01:14 AM
Replies: 89
Views: 1,325
Posted By fetchitfido
Re: Need a Front subframe

Other than needing to be from a '91-'93, there's no restriction on model for the front subframe (S-Series only). For the rear subframe it's better to get one from a SC/SC2/SL2/SW2 so you can more...
Forum: S-Series Tech 10-27-2020, 12:59 AM
Replies: 2
Views: 110
Posted By fetchitfido
Re: Color of wire on rear defrost on 1999 Saturn

Sounds like the dumbest way to fix a problem almost 100% guaranteed to have been fixed by unplugging the broken driver door buttons and replacing them. They pop out of the door in about 5 seconds.
...
Forum: S-Series General 10-24-2020, 07:47 PM
Replies: 10
Views: 272
Posted By fetchitfido
Re: PS Evo connector help

THAT? lmao
I've never seen anyone so flummoxed by a simple snap ring (>here (https://www.youtube.com/watch?v=egMsmseQpwE)<). I'm sorry. I shouldn't laugh as you obviously have no clue what you are...
Forum: S-Series General 10-24-2020, 11:19 AM
Replies: 10
Views: 272
Posted By fetchitfido
Re: PS Evo connector help

The connector lock isn't shown in your picture and even if it was, you just pull it out to let the connector lock tab fold away and slide the connector out.
If you don't want to use the EVO at speed...
Forum: S-Series General 10-21-2020, 09:35 AM
Replies: 10
Views: 326
Posted By fetchitfido
Re: Looking for black badge ?

"Yes" lol
1st gen they're all the same, 2nd gen and likely 3rd gen the Coupe's front one is bigger than the 4dr's.
Forum: S-Series Tech 10-19-2020, 01:58 PM
Replies: 17
Views: 297
Posted By fetchitfido
Re: Help! OBD ll code ( P3400 )

You'll have to give us a code that's valid for the '96-'02 S-Series first. The highest number code that's valid is P1696. Neither of your posted numbers are valid.
Forum: S-Series Tech 10-19-2020, 01:19 PM
Replies: 6
Views: 219
Posted By fetchitfido
Re: Aftermarket carpet source?

It's a full on 2x2" hole under both front seats. Could probably have it sewn up using the old carpet if you wanted.
Forum: S-Series Tech 10-18-2020, 12:09 AM
Replies: 6
Views: 219
Posted By fetchitfido
Re: Aftermarket carpet source?

Other than the cutouts for the rear foot warmers and slightly around the B-Pillars '96-'02 Sedan/Wagon carpets are compatible with '97-'02 Coupe's. Means there's holes under the front seats and the...
Forum: S-Series General 10-16-2020, 09:44 AM
Replies: 89
Views: 1,325
Posted By fetchitfido
Re: Need a Front subframe

There are 2 subframes, 1 for the engine and 1 for the rear suspension.
For '93 there are likely 2 subframes for the engine, it was a changeover year both for the height the radiator mounts and how...
Forum: S-Series Tech 10-16-2020, 12:34 AM
Replies: 10
Views: 226
Posted By fetchitfido
Re: Alternator connector

The connector and alternator changed halfway through the '97 model year. If it's built after January 1997, it's got the crap alternator (family name CS130D) and the more oval plug. If it's built...
Forum: S-Series Tech 10-12-2020, 01:27 PM
Replies: 6
Views: 147
Posted By fetchitfido
Re: Flywheel inspection cover fitment

Might depend on year and how the exhaust is routed. On whichever '93-'97 I was working on at the time there wasn't room to move the brace out of the way with the exhaust in place. Might have been one...
Forum: S-Series Tech 10-10-2020, 09:55 AM
Replies: 10
Views: 326
Posted By fetchitfido
Re: Wheel bearing press tool?

I like my 20t shop press from HF (https://www.harborfreight.com/20-ton-shop-press-32879.html) for doing wheel bearings, just make sure the stupid thing is level before you start or you run the risk...
Forum: S-Series Tech 10-10-2020, 09:48 AM
Replies: 6
Views: 147
Posted By fetchitfido
Re: Flywheel inspection cover fitment

They're the same. Quite fun to replace with the engine in the car, with dropping the exhaust and the engine/transmission brace.
Forum: S-Series General 10-10-2020, 09:47 AM
Replies: 24
Views: 569
Posted By fetchitfido
Re: Defelector spring

The air dam on the bottom that pretty much only the '91-'92 SC and '93-94 SC2's needed to keep cool while in traffic, and Saturn/GM fixed that issue with the redesigned bumper for '95-'96.
Forum: S-Series General 10-09-2020, 01:33 PM
Replies: 24
Views: 569
Posted By fetchitfido
Re: Defelector spring

Cheaper ($8ish shipped) on eBay: https://www.ebay.com/sch/i.html?_nkw=gm%2021030793
Forum: S-Series Tech 10-09-2020, 09:19 AM
Replies: 5
Views: 163
Posted By fetchitfido
Re: Coolant Temp Sensor

The correct answer is "Both". They are both temp sensors.

The 1-wire is for the gauge, the 2-wire is for the PCM and runs everything.
Forum: S-Series Tech 10-08-2020, 11:47 AM
Replies: 2
Views: 125
Posted By fetchitfido
Re: 97 sc2 vacuum line off throttle body

One goes to the fuel pressure regulator, the other to the canister purge solenoid.

The plastic thing on top of the TB as well as the TB itself looks unchanged from '91-'97 but they swapped which...
Forum: S-Series Tech 10-08-2020, 11:44 AM
Replies: 20
Views: 400
Posted By fetchitfido
Re: Replaced control arms resulted in wonky steering

Factory struts and some aftermarket struts have the outer layer of the knuckle mount elongated while the inner layer is not. There shouldn't be enough play in the bolt hole to have a noticeable...
Forum: S-Series General 10-07-2020, 02:02 PM
Replies: 6
Views: 310
Posted By fetchitfido
Re: Does anyone remember the oem Saturn parts website?

I've got these saved from years ago, I think a couple have changed, not sure.
http://www.gmpartsgiant.com/
http://www.gmpartsdirect.com/
http://www.trademotion.com/splash/index.cfm?siteid=214643...
Forum: S-Series General 10-04-2020, 11:57 PM
Replies: 7
Views: 180
Posted By fetchitfido
Re: Going to look at a Gen2 SL2

The BCM and all it entails is generic GM, the gauge cluster is generic GM, then there's the coil springs that break for no reason, the plastic intake manifold that breaks for no reason.
They're...
Forum: S-Series General 10-04-2020, 10:08 PM
Replies: 8
Views: 214
Posted By fetchitfido
Re: Problem: lost KEY FOB & car alarmed. What to do? (98 SL2)

Hop in, start the car and the alarm will turn off.
Use that RKE programming guide to turn the security/alarm feature off until you get replacement fobs (they're generic 90's GM models, just watch...
Forum: S-Series General 10-04-2020, 10:06 PM
Replies: 7
Views: 180
Posted By fetchitfido
Re: Going to look at a Gen2 SL2

I'd say there's less to worry about on a Gen 2 than a Gen 3, from just about every imaginable angle. Plastic bits might be a bit more brittle, rubber bits might be a bit more worn out but it's a full...
Forum: S-Series Tech 10-04-2020, 11:22 AM
Replies: 3
Views: 148
Posted By fetchitfido
Re: My SW2 keeps dying

The top bolt on the starters is 100% blind on 1st gens and at least 90% blind on the rest. Unless you swap it for a stud & nut (whatever size the intake manifold studs are) while the starter is out...
Forum: S-Series General 09-27-2020, 06:12 PM
Replies: 16
Views: 499
Posted By fetchitfido
Re: Saturns and the pandemic

If insurance wouldn't cover "acts of god" and you don't get penalized for essentially pausing coverage, then it won't hurt to drop insurance on it. If insurance would cover "acts of god" like hail or...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 09:41 AM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
SaturnFans.com. The Saturn Enthusiasts Site.