SaturnFans.com
saturnfans.com - classifieds - forums


Go Back   SaturnFans.com Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.55 seconds.
Search: Posts Made By: Waiex191
Forum: S-Series General 09-24-2022, 08:02 PM
Replies: 5
Views: 155
Posted By Waiex191
Forum: S-Series Tech 09-23-2022, 12:28 AM
Replies: 29
Views: 1,249
Posted By Waiex191
Re: Poor Headlight Performance

Tell us about your S Series!
Forum: S-Series Tech 09-19-2022, 09:28 PM
Replies: 21
Views: 307
Posted By Waiex191
Re: Saturn SL-1 clutch not *fully* dis-engaging

I wouldn't steer you wrong - the clutch bleed technique that holydiver posted back in 2011 is a good one!
Forum: Classifieds 09-18-2022, 11:28 AM
Replies: 3
Views: 133
Posted By Waiex191
Re: 96-99 knock sensor wanted

He said in an earlier thread that it was 100s of miles for him to get to a junkyard. Good way to make a couple of bucks and help out a fellow Saturn driver!
Forum: S-Series Tech 09-18-2022, 11:23 AM
Replies: 21
Views: 307
Posted By Waiex191
Re: Saturn SL-1 clutch not *fully* dis-engaging

The plus of pumping the slave, instead of the master, is that it pushes the bubbles in the correct direction so they may be able to escape via the reservoir.
Forum: S-Series Tech 09-18-2022, 09:39 AM
Replies: 21
Views: 307
Posted By Waiex191
Re: Saturn SL-1 clutch not *fully* dis-engaging

Pulling out the hydraulics is not hard. Try that bleeding procedure I linked. It it gets better, it was air.
Forum: S-Series Tech 09-17-2022, 05:49 PM
Replies: 21
Views: 374
Posted By Waiex191
Re: Loss of acceleration after a 5 mile drive

Favorite Local Auto Parts Store


We made ours. Not horrible.

http://www.saturnfans.com/forums/attachment.php?attachmentid=50452&d=1498860995
Forum: S-Series Tech 09-17-2022, 10:56 AM
Replies: 21
Views: 374
Posted By Waiex191
Re: Loss of acceleration after a 5 mile drive

You could easily make that gasket with gasket paper from your FLAPS.
Forum: S-Series Tech 09-16-2022, 02:35 PM
Replies: 21
Views: 307
Posted By Waiex191
Re: Saturn SL-1 clutch not *fully* dis-engaging

Here is the bleeding procedure I used:


Unfortunately the Wagner set is NLA.

The slave and master should be a set and never taken apart. So if they replaced the slave and it didn't work right,...
Forum: S-Series Tech 09-16-2022, 07:21 AM
Replies: 6
Views: 206
Posted By Waiex191
Re: Raybestos front brake hose Manufacturing defect

I used to be loyal to Raybestos. It's no longer a Connecticut company - it's all chinese. Centric is probably ok, but I avoid their rotors now as they degrade really quickly. We need more US...
Forum: S-Series Tech 09-15-2022, 10:27 PM
Replies: 9
Views: 341
Posted By Waiex191
Re: Stumbles/jerks on acceleration

Good job! I've been happy with the NGK coils I bought from Rock Auto.
Forum: S-Series Tech 09-11-2022, 03:30 PM
Replies: 16
Views: 338
Posted By Waiex191
Re: SC2 no crank

Pictures:
http://www.saturnfans.com/forums/attachment.php?attachmentid=51532&d=1507398253

http://www.saturnfans.com/forums/attachment.php?attachmentid=51533&d=1507398282

You can get to this...
Forum: S-Series Tech 09-11-2022, 03:25 PM
Replies: 16
Views: 338
Posted By Waiex191
Re: SC2 no crank

Sounds like a bad ignition switch. It's a super easy part to replace. I think it's held onto the lock cylinder with 2 screws and there is an electrical disconnect there too.
Forum: S-Series General 09-11-2022, 10:56 AM
Replies: 6,967
Views: 2,390,280
Posted By Waiex191
Re: What did you do to your S-Series today...

My driver's side wiper would go up smoothly, but chatter on the way down. I tried a few different brands of wiper blades. I'd always gone cheap but I tried the same wiper as on my wife's Lincoln,...
Forum: S-Series Tech 09-11-2022, 10:29 AM
Replies: 16
Views: 246
Posted By Waiex191
Re: Transmission Sound...

Check out my thread from post 174 down:
http://www.saturnfans.com/forums/showthread.php?t=230898&page=9

When the case is split, it is very easy to replace axle seals. If you just replaced yours,...
Forum: S-Series General 09-10-2022, 01:45 PM
Replies: 2
Views: 115
Posted By Waiex191
Re: Help! 1997 SW2

I'd check/replace the battery cables and verify the connections are good.
Forum: S-Series Tech 09-05-2022, 09:59 AM
Replies: 11
Views: 2,083
Posted By Waiex191
Re: The dredded rust at drivers rear trailing arm.

Are there Saturns in India? I didn't see any the time I went there.
Forum: S-Series General 09-02-2022, 11:05 PM
Replies: 6,967
Views: 2,390,280
Posted By Waiex191
Re: What did you do to your S-Series today...

Looks good. We've done the same thing a few times.
Forum: S-Series General 09-02-2022, 08:16 PM
Replies: 4
Views: 226
Posted By Waiex191
Re: I painted my wheels

Nice! Mine are pretty ugly.
Forum: S-Series General 09-01-2022, 10:35 AM
Replies: 156
Views: 5,300
Posted By Waiex191
Re: S series junkyard autopsies/who says small cars are unsafe?

The metal valve cover is small and easy to remove. There is a buyer in the forum looking for one.
Forum: S-Series General 09-01-2022, 08:47 AM
Replies: 6
Views: 252
Posted By Waiex191
Re: Need a DOHC Aluminum Valve Cover - 1993 - 1995

One thread up (currently) lanxer57 is asking if he should pull an aluminum valve cover from the junkyard. You should IM him or reply in his junkyard autopsy thread and see if you can work a deal.
Forum: S-Series Tech 08-25-2022, 01:06 PM
Replies: 18
Views: 2,010
Posted By Waiex191
Re: Trailing Arm

I recommend PB blaster soaks ahead of time, and an impact wrench instead of a breaker bar. You can't really get a torch on it.
Forum: S-Series Tech 08-24-2022, 09:50 PM
Replies: 18
Views: 2,010
Posted By Waiex191
Re: Trailing Arm

I can't remember why we didn't cut the end off. Probably concern about damage to the knuckle or where the sparks would fly to. Basically I cut one side of the nut. Look at the picture and you can...
Forum: S-Series General 08-24-2022, 09:47 PM
Replies: 17
Views: 493
Posted By Waiex191
Re: Cgg17's SW2 Thread

Nice! Now you need to update your signature.
Forum: S-Series Tech 08-24-2022, 05:45 PM
Replies: 18
Views: 2,010
Posted By Waiex191
Re: Trailing Arm

Don't drive it like that. The arms are not strong and braking will stress or bend them. We cut ours off. I think we got a pair of new Dorman arms from RA and swapped them out.

Check out post 353...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 07:20 AM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.
SaturnFans.com. The Saturn Enthusiasts Site.