SaturnFans.com
what's new (beta) - classifieds - forums - photos


Go Back   SaturnFans.com Forums > Search Forums
Register FAQ Members List Groups Calendar Chat Room Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 500
Search took 0.13 seconds.
Search: Posts Made By: ssicarman
Forum: S-Series Tech 09-03-2018, 09:07 PM
Replies: 4
Views: 197
Posted By ssicarman
Re: Did he toast stuff?

Purple wire goes to the start solenoid and is the signal wire to active the starter. Different years have the purple wire to different sides of the starter solenoid. The wire from the alternator...
Forum: Ion General 08-22-2018, 09:27 PM
Replies: 16
Views: 553
Posted By ssicarman
Re: Serious oil leak, my poor Ion's in trouble! (quarts daily)

Should be no oil external oil lines/hoses on the Saturn ION engine.
Oil leak is going to be from the oil filter cap or sealing o ring for the cap. Clean the area with brake clean so it is free from...
Forum: Vue Tech 08-19-2018, 11:09 AM
Replies: 15
Views: 384
Posted By ssicarman
Re: Rear diff clutches

Vue AWD rear diff is all mechanical.

From the service manual.

The rear drive module (RDM) in this vehicle consists of an aluminum housing which contains a gerotor fluid pump, clutch pack and a...
Forum: Vue General 08-17-2018, 10:01 PM
Replies: 5
Views: 273
Posted By ssicarman
Forum: Vue General 08-17-2018, 09:53 PM
Replies: 5
Views: 273
Posted By ssicarman
Re: 2007 Vue Power Window - Driver's

Assuming you are using an outside power and ground source to see if the window motor works.
Have you used a test light to see if there is power and ground to the motor connector when the switch is...
Forum: S-Series Tech 08-17-2018, 09:45 PM
Replies: 3
Views: 187
Posted By ssicarman
Re: sc2 axle seal question

The left side axle seal on the transmission is the only one with a snap ring on it. Not sure why they think the seal needs the snap ring to hold it in place but I would think that they felt it is...
Forum: L-Series Tech 08-06-2018, 03:30 PM
Replies: 14
Views: 498
Posted By ssicarman
Re: Oh No! Not again! brake issue. strange!

I would suspect that you have a sticking something in the braking system. The burning smell is likely from the brakes at the wheel (s) that have over heated and likely boiled the brake fluid giving...
Forum: S-Series Tech 08-03-2018, 08:30 PM
Replies: 7
Views: 198
Posted By ssicarman
Re: How do I remove ignition key lock cylinder

Doing the above to release the lock cylinder the key/cylinder you have it in the ACC position?
Forum: Aura General 07-23-2018, 09:42 PM
Replies: 4
Views: 382
Posted By ssicarman
Re: Do you need to drop the transmission to change the filter on a 2009 Saturn Aura x

Google is your friend.

http://www.atra.com/Webinars/GM/6T70_Introduction.pdf

Page 21 Shows the filter.

I am going with non serviceable unless you like pulling the transmission and splitting...
Forum: L-Series General 07-02-2018, 12:04 AM
Replies: 4
Views: 269
Posted By ssicarman
Re: 1993 sl1 vin9 SOHC front wheel locked not brakes

Drag marks from which tire/s?

If the front are both locking up and not moving the car forward I don't understand how you can get any drag marks trying to go forward.
Forum: Sky General 07-01-2018, 08:56 PM
Replies: 3
Views: 393
Posted By ssicarman
Re: How much is too much weight?

Your 300 pound 5 foot 10 man will not be comfortable driving a SKY. They are small tight cars.
Forum: S-Series Tech 06-30-2018, 08:15 PM
Replies: 4
Views: 200
Posted By ssicarman
Re: 2002 sl2 reservoir boils over at 1/2 way mark

Weak rad cap. Bad coolant temp sensor/temp sensor connector.
Forum: S-Series General 06-30-2018, 08:13 PM
Replies: 4
Views: 208
Posted By ssicarman
Re: How do I acess this in the engine bay?canister purge solenoid

The canister purge solenoid is located to the rear of the engine block, below the intake manifold above the starter solenoid.
Best accessed from under the car.
Forum: Vue General 06-30-2018, 02:23 PM
Replies: 5
Views: 275
Posted By ssicarman
Re: Uneven rear tire wear. Stumped.

The pictures are from a 2005 but I can't see them eliminating the adjustments for 2006.

The first picture should be the camber adjust and the second the toe adjust.


53486

53487
Forum: L-Series Tech 06-28-2018, 07:08 PM
Replies: 5
Views: 367
Posted By ssicarman
Re: need help, serious (time to come clean)

Cam and crank timing marks matching with the coloured links that should be on the timing chain.

53451

53452

53453
Forum: L-Series Tech 06-28-2018, 06:54 PM
Replies: 14
Views: 503
Posted By ssicarman
Re: L300 starts but doesn’t drive

The mystery piece is likely the oil level control valve.

53450
Forum: S-Series Tech 05-26-2018, 10:21 PM
Replies: 24
Views: 727
Posted By ssicarman
Re: SL1 TAAT transmission mystery

From the service manual.

Transaxle Shifts
Transaxle shifts are controlled by the manual valve and the PCM through the hydraulic solenoids.

The manual valve controls oil direction to provide...
Forum: Ion General 05-25-2018, 10:13 PM
Replies: 5
Views: 289
Posted By ssicarman
Re: Rusted looking rim

A wire brush to clean the loose rust off and a rattle can of Tremclad.
Forum: S-Series General 05-22-2018, 08:33 PM
Replies: 15
Views: 305
Posted By ssicarman
Re: 01 sc1 overheated seized bottom end?

On the engine there is nothing that is different between an engine that goes into an auto transmission car or a manual transmission car. Remove the flex plate and install the flywheel. You now have a...
Forum: L-Series General 05-22-2018, 08:26 PM
Replies: 2
A/c
Views: 254
Posted By ssicarman
Re: A/c

A ground for what on the A/C compressor? Assuming the clutch? The connector for to the Compressor how many wires?

More importantly what is the A/C doing or not doing?
Forum: Vue General 05-12-2018, 11:22 PM
Replies: 6
Views: 332
Posted By ssicarman
Re: 2.2l oil pan gasket not available?

You have me confused.

What does me answering your question about the oil pan gasket have to do with you finding metal in the oil pan?
Forum: Vue General 05-12-2018, 02:05 PM
Replies: 6
Views: 332
Posted By ssicarman
Re: 2.2l oil pan gasket not available?

The gasket will be RTV silicon. No preformed type of gasket is used.
Forum: S-Series General 05-05-2018, 09:50 PM
Replies: 12
Views: 462
Posted By ssicarman
Re: 97 saturn sl1 A.C. work

Initial thought is that you have to much oil in the system.
The total amount of oil in the system should be 5 ounces. Ideally the oil should be drained from the original compressor so that the...
Forum: Ion General 04-07-2018, 07:22 PM
Replies: 17
Views: 1,815
Posted By ssicarman
Re: Fan Control not working

HVAC Blower Motor Inoperative and/or Blower Speed is Higher/Lower than Requested Speed (Replace HVAC Control Assembly) #03-01-38-004 - (May 1, 2003)
HVAC Blower Motor Inoperative and/or Blower Speed...
Forum: Vue Tech 03-26-2018, 08:29 PM
Replies: 5
Views: 463
Posted By ssicarman
Re: Slow-to-release brakes and brake groan fixed!

It is not so much the brake hose collapsing. It is the metal bracket on the hose rusting and squeezing the hose closed. If the bracket was expanded open then the issue would likely go away.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 02:35 PM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
SaturnFans.com. The Saturn Enthusiasts Site.