SaturnFans.com
what's new (beta) - classifieds - forums - photos


Go Back   SaturnFans.com Forums > Search Forums
Register FAQ Members List Groups Calendar Chat Room Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 80
Search took 0.07 seconds.
Search: Posts Made By: ampecsu
Forum: S-Series Tech 02-20-2018, 08:11 AM
Replies: 21
Views: 407
Posted By ampecsu
Re: Very quick EGR valve question

...Well the shop put in three years ago what was said to be a '98 ... thats all I know.

The egr I pulled and put on yesterday was from a 99 after checking autozone part vehicle fitment...did I...
Forum: S-Series Tech 02-19-2018, 06:50 PM
Replies: 21
Views: 407
Posted By ampecsu
Re: Very quick EGR valve question

thanks. looks like at least 94-99
Forum: S-Series Tech 02-19-2018, 03:45 PM
Replies: 21
Views: 407
Posted By ampecsu
Very quick EGR valve question

1995 sl2 (98 motor.)..Over-tightened and broke egr valve while fixing vacuum leak.

Swap guide was little confusing here.

What is the highest year I can pull from to replace? 98?
Forum: S-Series General 02-17-2018, 02:56 PM
Replies: 9
Views: 354
Posted By ampecsu
Dizzy Re: O2 sensor part or other root cause?

...sprayed around some brake cleaner. Egr valve needed more tightening. Probably could still use a gasket.

Picked up a an ECTS from a 2002 which I think is the brass one?? (check pic...
Forum: S-Series General 02-17-2018, 02:50 AM
Replies: 9
Views: 354
Posted By ampecsu
Re: O2 sensor part or other root cause?

THanks a lot! I'll take a look at those things in the a.m!
Forum: S-Series General 02-16-2018, 01:45 PM
Replies: 9
Views: 354
Posted By ampecsu
Re: O2 sensor part or other root cause?

here were my spark plugs:https://postimg.org/image/c1v20i1kv/

I was able to finally get to the ground behind the motor above the starter and and cleaned the two wires (cleaned alternator and...
Forum: S-Series General 02-08-2018, 10:33 AM
Replies: 9
Views: 354
Posted By ampecsu
Forum: S-Series General 02-06-2018, 11:28 AM
Replies: 9
Views: 354
Posted By ampecsu
Re: O2 sensor part or other root cause?

Finally getting a chance to look at the car. Having trouble finding those grounds.

But I do have these two wires hanging, one tan and one black/dark brown(I do believe they used to be connected...
Forum: S-Series General 02-03-2018, 07:42 AM
Replies: 9
Views: 354
Posted By ampecsu
O2 sensor part or other root cause?

My 95 sl2 is finally showing a 13 code after a few months of driving with a new o2 sensor (no codes before with old sensor). Before my gas mileage had been DRASTICALLY reduced over a years time from...
Forum: S-Series Tech 10-20-2017, 09:44 AM
Replies: 14
Views: 423
Posted By ampecsu
Re: Engine cradle/subframe bolts difficulty

What are numbers refering to? 10.9? Nevermind looked it up. Ignore
Forum: S-Series Tech 10-19-2017, 03:08 PM
Replies: 14
Views: 423
Posted By ampecsu
Re: Engine cradle/subframe bolts difficulty

Thanks all of you for your input I just finished the job. I went and bought a breaker bar and got the sockets to fit it from the pawn shop for some change. The bolts came out pretty easily at the...
Forum: S-Series Tech 10-19-2017, 03:14 AM
Replies: 14
Views: 423
Posted By ampecsu
Re: Engine cradle/subframe bolts difficulty

Thanks for the response. I'll have to pick up a socket to fit my 1/2 ratchet. or breaker bar I guess. If I'm reading this diagram correctly, the passenger side needs retainers and the driver side...
Forum: S-Series Tech 10-19-2017, 12:21 AM
Replies: 14
Views: 423
Posted By ampecsu
Engine cradle/subframe bolts difficulty

this post is a continuation of my alignment issue discovery http://www.saturnfans.com/forums/showthread.php?p=2257287#post2257287

I went to the junkyard to attempt to pull the two bolts I need but...
Forum: S-Series Tech 10-18-2017, 02:27 PM
Replies: 8
Views: 356
Posted By ampecsu
Re: Alignment issue my fault??

Update
So, wow, I took it back and I'm missing two subframe bolts....On the passenger side. One behind the tire and one in front that was apparently missing so the frame was welded back on(weld now...
Forum: S-Series Tech 10-17-2017, 10:47 PM
Replies: 8
Views: 356
Posted By ampecsu
Re: Alignment issue my fault??

my car can still have the camber aligned without this kit, right?? I need to take it back to them and have them redo it if so
Forum: S-Series Tech 10-17-2017, 08:26 PM
Replies: 8
Views: 356
Posted By ampecsu
Re: Alignment issue my fault??

they said the kit was only about $23.
Forum: S-Series Tech 10-17-2017, 06:39 PM
Replies: 8
Views: 356
Posted By ampecsu
Alignment issue my fault??

I can think of 2 alignments Ive had prior and they turned out fine. This time I took it in to precision tune again to have on done after I put on a pair inner and outer tie rods and lower control...
Forum: General Saturn Discussion 10-16-2017, 05:42 PM
Replies: 1
Views: 348
Posted By ampecsu
Re: Grease Gun Storage

think I see something that says just pull the plunger out...
Forum: General Saturn Discussion 10-16-2017, 05:02 PM
Replies: 1
Views: 348
Posted By ampecsu
Grease Gun Storage

I keep seeing that one should depressurize the gun to store cartridge in the gun but how?
Forum: S-Series Tech 10-14-2017, 09:11 PM
Replies: 7
Views: 213
Posted By ampecsu
Re: Tie Rod end greasing question

Mine wasn't already screwed on either. I saw a little bit of something that had a clear ar yellowish vasilene appearance. But like i said the boot felt and sounded dry.
Forum: S-Series Tech 10-14-2017, 06:33 PM
Replies: 7
Views: 213
Posted By ampecsu
Re: Tie Rod end greasing question

OK THANKS!! now I'm going to find the cheapest way to get it done.
Forum: S-Series Tech 10-14-2017, 03:34 PM
Replies: 7
Views: 213
Posted By ampecsu
Re: Tie Rod end greasing question

So I need to add grease first since it has the fitting. OK thanks!

oh one last thing can I add the grease while its already tightened down with the castle nut or do I have loosen it??
Forum: S-Series Tech 10-14-2017, 02:28 PM
Replies: 7
Views: 213
Posted By ampecsu
Tie Rod end greasing question

I just replaced my inner and outer tie rods. I that it has a grease fitting. Do all outer tie rod ends come pre-greased. I not sure since to boot as and "airy" sound when squeezed.

Is it ok to...
Forum: S-Series Tech 09-28-2017, 12:03 AM
Replies: 7
Views: 226
Posted By ampecsu
Re: Quick Sway Bar Link question

I saw it included in a set while shopping on ebay and wanted to make sure I wasn't overlooking something while replacing tie rods and control arms. ALL BUSTED. thanks.
Forum: S-Series Tech 09-27-2017, 01:56 PM
Replies: 7
Views: 226
Posted By ampecsu
Re: Quick Sway Bar Link question

I see the notes for that image are "rear." So I won't be using that.
Showing results 1 to 25 of 80

 
Forum Jump

All times are GMT -5. The time now is 12:06 PM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
SaturnFans.com. The Saturn Enthusiasts Site.