SaturnFans.com
what's new (beta) - classifieds - forums - photos


Go Back   SaturnFans.com Forums > Search Forums
Register FAQ Members List Groups Calendar Chat Room Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 500
Search took 0.54 seconds.
Search: Posts Made By: satlite440
Forum: General Saturn Discussion 05-02-2018, 08:18 PM
Replies: 10
Views: 643
Posted By satlite440
Re: I purchased a clone Tech 2, ask me anything.

not sure what programming you think your going to do..i to have a tech2&candi clone..it works when it wants(intermitanly the screen will drop out.but it was free so no complaints)..the way we used...
Forum: Outlook General 05-02-2018, 07:40 PM
Replies: 5
Views: 2,145
Posted By satlite440
Re: 6t75 Solenoid removal

in the slot where the red cpa slides in under the center of the hoop of the lever use a pocket screwdriver to press in/down to unlock the 1st stage of the lever hoop/arm..then pull lever to...
Forum: Vue Tech 04-29-2018, 12:16 PM
Replies: 3
Views: 385
Posted By satlite440
Re: Replace torque converter without rebuilding transmission?

as a dealertrans tec for gm..if a unit has 100k on the clock but runs fine I would do that..over 100k depends on condition and let cust know war only covers leaks and tcc operation...if I put it in...
Forum: 2008 Vue 04-18-2018, 07:31 PM
Replies: 20
Views: 634
Posted By satlite440
Re: Head Gasket???

thank you very much gm7 have been busy changing a charging port and the cable that goes to the onboard charging module for a volt for a bad proxcimty ctk fault..glad tho here rig's running good..
Forum: 2008 Vue 04-17-2018, 10:25 PM
Replies: 20
Views: 634
Posted By satlite440
Re: Head Gasket???

also I'm assuming yours is simaler to an acadia/enclave.the quirk fittings for the heater core hose quick fittings leak and run down the rear pipe and pool up in the 10clock bolt pocket for the...
Forum: 2008 Vue 04-17-2018, 07:57 PM
Replies: 20
Views: 634
Posted By satlite440
Re: Head Gasket???

afternoon gents..for some reason I can see you pic.s just a black box with an x in it..that said there is a water outlet neck above the w/p you have already changed there is an oring and a molded...
Forum: Vue Green Line 12-01-2017, 10:42 PM
Replies: 26
Views: 1,493
Posted By satlite440
Re: intermitten p1174 (Fuel Trim Balance)

ok so if you were to pull the rear o2 it would set a slow response time code as it was out in ambiante air and would have a flatlined lean signal. long before a p0420 would set and since the p1174 is...
Forum: Vue Green Line 12-01-2017, 12:08 AM
Replies: 26
Views: 1,493
Posted By satlite440
Re: intermitten p1174 (Fuel Trim Balance)

as to where I got this info is from gm.im a 20yr master ase cirtified, and a gm master tech in auto trans/manual drive train and axle/engine repair and brakes..i cant' show you any of this as you...
Forum: Vue Green Line 11-29-2017, 08:54 PM
Replies: 26
Views: 1,493
Posted By satlite440
Re: intermitten p1174 (Fuel Trim Balance)

so this dtc is basicly a random sampling of pre and post cat o2 reading when a specific cyclinder is 4 degrees after tdc ignition..it is a predicted model based of of one of the 3 intake performance...
Forum: Vue Tech 11-28-2017, 10:08 PM
Replies: 24
Views: 921
Posted By satlite440
Re: Idle relearn / DTC issues after new TB installation

try this
Throttle Learn
Note: If Throttle or Idle Learn does not display on the scan tool menu go directly to the Service Bay/On Road Learn Procedure.

Scan Tool Idle Learn or Idle Learn Reset...
Forum: Vue Green Line 11-28-2017, 09:52 PM
Replies: 26
Views: 1,493
Posted By satlite440
Re: intermitten p1174 (Fuel Trim Balance)

depending on the age and milage and the fact you had a p0303 before?..i would consider replaceing the intake manifold gaskets as they flatten out and can suck air.. this dtc is a random sampleing of...
Forum: Vue Green Line 11-28-2017, 09:41 PM
Replies: 26
Views: 1,493
Posted By satlite440
Re: intermitten p1174 (Fuel Trim Balance)

since you didn't bother to post the basic's year make model and engine size this is an educated guess as to the specific p1174 table from 09 and there are 7 different possible moter but you did say 4...
Forum: Vue Green Line 11-28-2017, 09:36 PM
Replies: 26
Views: 1,493
Posted By satlite440
Re: intermitten p1174 (Fuel Trim Balance)

DTC P1174
Diagnostic Instructions
•Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
•Review Strategy Based Diagnosis for an overview of the diagnostic...
Forum: L-Series General 10-09-2017, 07:29 PM
Replies: 3
Views: 409
Posted By satlite440
Re: 2000 Sl1 Auromatic Transmission diagnosis

the fact that you can go for a short while then stops indicates a plugged filter. be aware the sl's have 2 filters 1 spin on external filter. 1 internal filter only replaceable if the case is split...
Forum: S-Series Tech 10-04-2017, 03:09 PM
Replies: 3
Views: 350
Posted By satlite440
Re: ATF & TCC unlocking

po741 is an often misunderstood dtc...the term "stuck off" is not totally correct..it is stuck off due to the ecm or tcm in charge of tcc lock up making a decision that evan at 100% pwm on time it...
Forum: 2008 Vue 10-04-2017, 10:03 AM
Replies: 15
Views: 999
Posted By satlite440
Re: 3.6 education

my 1t choice would be buy the updated cover&gasket.. or enlarge the inner pair of holes..not the outer1. the reason for this is you can get a p0171&p0174 lean codes a this is considered unmetered air...
Forum: 2008 Vue 10-03-2017, 10:32 PM
Replies: 15
Views: 999
Posted By satlite440
Re: 3.6 education

actuly as designed the bank 2 next to radiator on sidewinders and drivers side on longitudal mout. is the fresh air intake for the pcv system..the bank 1 rear cover has the fixed orifice pcv...
Forum: S-Series Tech 10-01-2017, 11:50 AM
Replies: 11
Views: 379
Posted By satlite440
Re: fuel pump voltage

high resistance from a poor ground can aslo cause this
Forum: Astra Tech 09-29-2017, 02:37 PM
Replies: 4
Views: 445
Posted By satlite440
Re: Trouble getting a new key programmed

as a dealer tech the issue is the tech2's mass storage card..i hold a limited amout of data/programing..so you can have version 33.004 north American operation loaded or Saturn/ astra.. some dealers...
Forum: S-Series Tech 09-29-2017, 12:21 PM
Replies: 16
Views: 442
Posted By satlite440
Re: Brake line rusted out

I was just pointing out an option not judgeing or trying to read someones comfotableness with doing something like bending or flareing..both are easy for me due to yrs of practice.but evan I wont do...
Forum: S-Series Tech 09-29-2017, 11:39 AM
Replies: 16
Views: 442
Posted By satlite440
Re: Brake line rusted out

for all thoses who are chalanged or don't want to bend their own..almost all larger city's have a local hose&fitting store/shop that sevices industrial/construction type hoses&pipes.we have one here...
Forum: 2008 Vue 09-28-2017, 09:47 AM
Replies: 53
Views: 1,589
Posted By satlite440
Re: 3.6 timing chain question

gm7 yes and no..there is and event log in every module.we in the field can only access if a dtc was set. say a p0717 speed sensor dtc was set due to the 3-5-r failing..there would be...
Forum: Vue Tech 09-28-2017, 12:00 AM
Replies: 7
Views: 382
Posted By satlite440
Forum: 2008 Vue 09-27-2017, 11:45 PM
Replies: 53
Views: 1,589
Posted By satlite440
Re: 3.6 timing chain question

Also, I will agree, I did badly ask those questions. So here they are more clearly.
How much of a PITA is it to do the timing chain, tensioners and guides in the car?

nothing I would want to...
Forum: 2008 Vue 09-27-2017, 08:54 PM
Replies: 53
Views: 1,589
Posted By satlite440
Re: 3.6 timing chain question

well you guys went a long way.. so I will start as best I can...a war timming chain job pays the tec about 8hrs that's drop whole subframe with trans/tcase/engine this is only done for head or chains...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 04:53 AM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
SaturnFans.com. The Saturn Enthusiasts Site.