SaturnFans.com
what's new (beta) - classifieds - forums - photos


Go Back   SaturnFans.com Forums > Search Forums
Register FAQ Members List Groups Calendar Chat Room Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 421
Search took 0.10 seconds.
Search: Posts Made By: waiter21
Forum: Vue Tech 02-17-2018, 08:41 AM
Replies: 7
Views: 188
Posted By waiter21
Re: 2005 vue, 2.2L manual issue revving

Clean and check electrical grounds. A bad or missing ground will cause this.. Remove the ground use a wire brush, sand paper, etc to clean the connector and the ground surfaces.

Add a couple...
Forum: Vue General 02-16-2018, 12:15 PM
Replies: 28
Views: 512
Posted By waiter21
Re: Transmission Swap No Start

I have diagrams for a 2002. Not sure how close they would be.

send me a PM or give me your email and I'll send it to you. The file is a 3.6 meg PDF.
Forum: 2008 Vue 02-14-2018, 07:09 AM
Replies: 5
Views: 144
Posted By waiter21
Re: Help With Locating a Part

Mine were rusted out. I replaced them with hose.

My fuel line and the canister lines were both rusted. I replaced the fuel line with high pressure hose and fuel line clamps. I replaced the...
Forum: Vue General 02-13-2018, 09:33 AM
Replies: 6
Views: 141
Posted By waiter21
Re: 2.2 ecotec removal top or bottom 05 Vue

The entire assembly, probably not.

I'm thinking:

If you remove the hood, use a floor crane (hoist) to lift/support the engine / tranny / cradle assembly from the top. After everything is...
Forum: Vue General 02-13-2018, 08:40 AM
Replies: 9
Views: 265
Posted By waiter21
Re: Another new VUE

EXCELLENT - Another Vue revived.

We should start a "Rescued Vue club".. :)
Forum: Vue General 02-13-2018, 08:38 AM
Replies: 8
Views: 134
Posted By waiter21
Re: Help with 05 Vue

About the same amount of work, but coming out the bottom on the cradle is cleaner.

You didn't mention the transmission??? If its a manual, I'd replace the clutch and slave cylinder while you...
Forum: Vue General 02-13-2018, 08:15 AM
Replies: 6
Views: 141
Posted By waiter21
Re: 2.2 ecotec removal top or bottom 05 Vue

When I replaced my clutch, I looked at this subject carefully.

I finally came to the conclusion it would be about the same amount of effort either way, so I decided to drop the cradle..

In...
Forum: Vue Tech 02-13-2018, 07:59 AM
Replies: 12
Views: 273
Posted By waiter21
Re: Random idle issue and random hiccup

Clean ground connections on engine and frame.

http://www.saturnfans.com/forums/showthread.php?t=216101

..
Forum: Vue General 02-12-2018, 07:51 AM
Replies: 28
Views: 512
Posted By waiter21
Re: Transmission Swap No Start

14.35 is a little low, should be 14.6 or 14.7 If your near a junk yard, buy a used one off of any 2.2 engine.

O2 sensor could also be a posibility..

the 195 degree point is probably the...
Forum: Vue General 02-10-2018, 08:25 PM
Replies: 28
Views: 512
Posted By waiter21
Re: Transmission Swap No Start

MAP sensor... If I remember right, its tucked uo under/beside the throttle body..

Can you look at sensor sats with your scanner??
Forum: Vue General 02-10-2018, 10:18 AM
Replies: 11
Views: 262
Posted By waiter21
Re: Catalytic converter replacement

II added two spaces on my 2.2, completely eliminated the 420s

http://www.saturnfans.com/forums/showthread.php?p=2193404

As for the 443 - I have two Evap valves, one on the engine and one on...
Forum: Vue General 02-10-2018, 10:08 AM
Replies: 28
Views: 512
Posted By waiter21
Forum: Vue General 02-09-2018, 11:51 AM
Replies: 28
Views: 512
Posted By waiter21
Re: Transmission Swap No Start

I didn't get the manual. Can you send it to me at

waiter@iflyez.com

Tnks
Forum: Vue General 02-09-2018, 11:38 AM
Replies: 6
Views: 251
Posted By waiter21
Re: Vue power problem

I would think a plugged cat converter would show up under high throttle, and/or high rpm...

P-0172 is a fuel trim issue. The computer is adding more fuel to the baseline than it thinks its...
Forum: Vue General 02-09-2018, 11:23 AM
Replies: 28
Views: 512
Posted By waiter21
Re: Transmission Swap No Start

P0171 - Did you install new o-rings on the intake manifold... (I think you said you did) Mine were crushed flat and had vacuum leaks that were causing the 171 trim.. Look at post #7.. Don't...
Forum: Vue Red Line 02-08-2018, 07:36 AM
Replies: 4
Views: 384
Posted By waiter21
Re: 04' Redline front end vibration

Bad front bearings. very common problem.

Mine developed a kind of a buzzing vibration sound / feel. I replaced both sides. The old left side was probably ok, but the bearing from the passenger...
Forum: Vue General 02-07-2018, 04:55 PM
Replies: 28
Views: 512
Posted By waiter21
Re: Transmission Swap No Start

There are a lot of Vues with trashed VTIs.. It sounds like an Af23 swap might be an interesting winter project..

I'll send you a PM if you'll send me the manual also. I'm interested to see what...
Forum: Vue General 02-07-2018, 04:47 PM
Replies: 28
Views: 512
Posted By waiter21
Re: Transmission Swap No Start

Glad to see you got it running...

I bypassed my passlock with a resistor. Works great when I use a remote starter.

http://www.saturnfans.com/forums/showthread.php?t=215634

NOTE - If you...
Forum: Vue General 02-07-2018, 04:43 PM
Replies: 28
Views: 512
Posted By waiter21
Re: Transmission Swap No Start

My experience is with a VTI to manual swap..

Any codes set on the ECM??

Did you swap ECMs? On my VTI to Manual swap, the ECM had to be swapped to support the manual tranny. (different ECM...
Forum: Vue General 02-01-2018, 06:50 PM
Replies: 6
Views: 244
Posted By waiter21
Re: Engine swapquestion for 2004 Vue

verify the PCV orifice is clear.. with the engine idling, remove the oil checl tube. Use your finger, on the tube, there should be slight vacuum.

The orifice is on the head and will require the...
Forum: Vue General 01-17-2018, 11:43 AM
Replies: 7
Views: 169
Posted By waiter21
Re: 05 saturn vue, crank no start

Yes, a bad crank position sensor will cause this problem.

Before replacing, I would do a quick compression test. This will tell you if the timing chain has jumped timing. (common problem with...
Forum: Vue General 01-11-2018, 10:46 AM
Replies: 6
Views: 244
Posted By waiter21
Re: Engine swapquestion for 2004 Vue

Yes, it should.

IMPORTANT - If you pull the 02 engine, before installing it in the other vehicle, I'd replace the timing chain and components.

The two weak components in the 02 were the...
Forum: Vue Tech 12-13-2017, 04:08 PM
Replies: 13
Views: 401
Posted By waiter21
Re: 2003 V6 3.0L; Oil leaking; What's this called?

These shouldn't have any pressure in them.. Normally the cooler is the last stop before fluid gets dropped back into the pan. so the only pressure (if nothing is plugged) would be the small...
Forum: Vue Tech 12-13-2017, 03:56 PM
Replies: 3
Views: 229
Posted By waiter21
Re: security light?

I'm not sure if the Passlock system would cause a limp mode...

However, If you wish to bypass the Passlock system, this is how I did it..
...
Forum: Vue General 12-09-2017, 09:16 AM
Replies: 10
Views: 409
Posted By waiter21
Re: GM Ignition Recall - Tech Impressed...

You can buy a new cylinder with keys for about $35, Amazon, ebay, etc.

If you plan on removing the lock paw, I would recommend finding a lock assembly at a junk yard, and experiment with it.
...
Showing results 1 to 25 of 421

 
Forum Jump

All times are GMT -5. The time now is 08:39 PM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
SaturnFans.com. The Saturn Enthusiasts Site.