Forum: Vue General
02-25-2020, 12:05 PM
|
|
Replies: 10
Views: 2,243
|
|
Forum: Vue Tech
08-01-2019, 06:51 PM
|
|
Replies: 9
Views: 757
Re: Starting and possible bad ECU
I would check fuel pressure. See thumbnail to locate test port. Check for healthy spray if you don't have a gauge.
Its normal for CEL to remain on until engine starts.
Does your OBD device have...
|
|
Forum: Vue General
07-16-2019, 09:59 AM
|
|
Replies: 2
Views: 550
Re: Making sure I do it right the first time.
I received your private message but you didn't include email address.
Matters not at this point since I determined the referenced files do not exceed forum limits.
Three coolant system files...
|
|
Forum: Vue General
07-14-2019, 10:31 PM
|
|
Replies: 2
Views: 550
Re: Making sure I do it right the first time.
RPO number for Honda 3.5 V6 is L66.
L61 is RPO for 2.2 4 cyl.
L81 is RPO for 3.0 V6 engine.
Thumbnail lists basic steps needed to flush 3.5 (L66) system and I can email all the listed...
|
|
Forum: Vue General
07-11-2019, 06:42 PM
|
|
Replies: 10
Views: 576
Re: diagnostic help
Low coolant sensor is on end of electrical connector.
Sensor can get really "gunked" but can be cleaned 99% of time with strong stream of water.
|
|
Forum: Vue Tech
07-11-2019, 02:15 PM
|
|
Replies: 4
Views: 694
|
|
Forum: Vue Tech
07-10-2019, 11:01 PM
|
|
Replies: 46
Views: 2,749
Re: 06 Redline will not run/idle while cold
As if water is not muddy enough - I'll stir the pot.
What if you have loose or broken wire at CKP? I've attached diagram if you have meter and time to run wires back to PCM.
I've attached...
|
|
Forum: Vue General
07-10-2019, 10:41 PM
|
|
Replies: 2
Views: 435
Re: 2006 Vue L4 Starting Issue
I don't recall seeing that security feature anywhere, ever.
I briefly studied ignition and turn signal wiring and don't see any plausible relationship but don't doubt your claim you need to place...
|
|
Forum: Vue General
07-10-2019, 10:16 AM
|
|
Replies: 23
Views: 1,387
|
|
Forum: Vue Tech
07-07-2019, 11:20 PM
|
|
Replies: 1
Views: 432
Re: Brake lights/cruise control not working
You may not still need advice but sunroof water usually soaks connector C200 which is behind the kick panel next to drivers left foot.
The panel is one piece with several friction fasteners and...
|
|
Forum: Vue General
07-07-2019, 01:15 PM
|
|
Replies: 1
Views: 427
Re: Rough idle Then stalls out
Here are a few things I recall about Vue fuel system.
According to FSM you'd expect 60 psi when pump builds full fuel pressure.
Turning key to ON/RUN will give 2 seconds of fuel pump run and...
|
|
Forum: Vue General
07-07-2019, 12:24 PM
|
|
Replies: 2
Views: 432
Re: Transmision fluid temperature sensor
ATF temp is available at OBD2 port.
I have ScanGaugeII connected to three family Vue's to monitor temps.
You'll need to create a new gauge to read but directions are available and easy to...
|
|
Forum: Vue Tech
07-07-2019, 12:17 PM
|
|
Replies: 185
Views: 36,034
Re: Lo Idle AC mystery solved.
I've changed valves on three of four family 3.5 Vue's.
Not a big deal to change but you definitely need means to remove and store refrigerant.
New valve kits are available on Amazon for $10 and...
|
|
Forum: 2008 Vue
04-15-2019, 10:39 AM
|
|
Replies: 5
Views: 648
|
|
Forum: Vue General
04-10-2019, 10:56 PM
|
|
Replies: 1
Views: 306
Re: 2007 Saturn Vue Doors will not open
Locks consistently working only with engine running sounds like a power supply problem.
Door lock/unlock actuators can become "lazy" as years pile up.
Internal wiring resistance should not...
|
|
Forum: Vue Tech
04-03-2019, 10:42 PM
|
|
Replies: 11
Views: 524
Re: Battery light
That thumbnail appears to be from 05 Vue owners manual but isn't correct.
I've posted extract from 2007 owners manual which applies to 05, 06 or 07 Vue's and I don't have earlier year to compare...
|
|
Forum: Vue Tech
04-03-2019, 11:39 AM
|
|
Replies: 6
Views: 868
Re: 2004 VUE transfer case or RDM noise?
Here's listing for several Honda transfer cases - fits 04-07 Vue with AWD:
https://www.ebay.com/sch/i.html?_from=R40&_trksid=m570.l1313&_nkw=2007+saturn+vue+transfer+case&_sacat=0
|
|
Forum: Vue Tech
04-02-2019, 01:56 PM
|
|
Replies: 10
Views: 2,555
Re: Completed valve adjustment on my 3.5
Bank 1 - nearest cabin - cylinders are 1, 2 and 3 counting from front of engine (accessory belt end) to rear (toward transmission).
Bank 2 - nearest radiator cylinders are 4, 5 and 6 front to rear.
|
|
Forum: Vue General
03-30-2019, 02:10 PM
|
|
Replies: 5
Views: 286
Re: 05 vue v6
Having locksmith nearby is a good thing. ;)
I agree with key being non-chip, typical for 02-07 Vue's.
Theft deterrent is a replaceable PASSLOCK sensor circuit embedded in lock cylinder housing....
|
|
Forum: Vue General
03-30-2019, 10:58 AM
|
|
Replies: 1
Views: 338
|
|
Forum: Vue General
03-30-2019, 10:36 AM
|
|
Replies: 5
Views: 286
Re: 05 vue v6
"Hotwire" probably means owner bypassed resistor in ignition cylinder with external resistor - or perhaps installed a commonly available universal learning bypass module such as JBS Model 791.
...
|
|
Forum: Vue Tech
03-26-2019, 10:12 AM
|
|
Replies: 3
Views: 598
Re: High Beams Stay On
One side of headlamps are "hard-wired" to battery (thru fuses).
Possible causes of high beams staying on:
1. Ground side wire of lighting circuit intermittently shorted to ground or one of...
|
|
Forum: Vue Tech
03-24-2019, 07:15 PM
|
|
Replies: 11
Views: 912
Re: 07 Saturn Vue Not Starting
These steps check wiring connected to ECM - not internal ECM.
You want to make sure voltages are getting to ECM - the procedures ask you to check for shorts and opens.
However, if you have test...
|
|
Forum: Vue Tech
03-21-2019, 07:05 PM
|
|
Replies: 11
Views: 912
Re: 07 Saturn Vue Not Starting
I've attached a few extracts.
P1682 could be a factor for crank but no run.
P0116 is listed for 2.4 and 3.5 but not for 2.2 engine - I attached anyway
Po118 attached in case you also wanted...
|
|
Forum: Vue Tech
03-19-2019, 06:17 PM
|
|
Replies: 46
Views: 2,749
Re: 06 Redline will not run/idle while cold
Possibilities are a marginal PCM contact, You disconnected IAT to remove air box. CKP or CMP view of sprocket might be obscured.
Idle learn isn't always required after TB change but FSM...
|
