what's new (beta) - classifieds - forums - photos

Go Back Forums > Search Forums
Register FAQ Members List Groups Calendar Chat Room Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 500
Search took 0.46 seconds.
Search: Posts Made By: bern
Forum: Ion Tech 01-19-2020, 08:58 PM
Replies: 13
Views: 316
Posted By bern
Re: 2005 Ion limp mode and then some!

With the car back into The Body Shop. Your son in law should remove the body control module and inside fuse box combo that is located under the instrument panel in the forward part of the center...
Forum: 2008 Vue 01-18-2020, 12:01 AM
Replies: 3
Views: 228
Posted By bern
Re: 08 Vue 3.6L massive oil leak

The PCV office in the right (rear) valve cover is likely plugged. this may crank case pressure to push oil back wards out the fresh air side of the pcv system and / or any seal or gasket see:
Forum: Vue Tech 12-28-2019, 02:57 PM
Replies: 11
Views: 469
Posted By bern
Re: V6 Rattling noise - gone when warm

The 3.5 liter V-6 Engine dose not have Hydraulic lifters. It has solid lifters and if one or more were loose they would make noise all of the time and would not change with engine temperature...
Forum: Vue Tech 12-28-2019, 02:37 PM
Replies: 3
Views: 248
Posted By bern
Re: P0171 System Too Lean Bank 1

The P0171 DTC is usually set when their is a vacuum leak. You can spray Brake cleaner or carburetor cleaner Around the intake manifold, the brake booster hose, the purge valve hose. test the purge...
Forum: Ion Tech 12-17-2019, 11:47 PM
Replies: 5
Views: 232
Posted By bern
Re: No heat please help

maybe you have a blown head gasket. pressure test the cooling system with the spark plugs out.
Forum: Vue Tech 12-17-2019, 11:27 PM
Replies: 4
Views: 323
Posted By bern
Re: Auto fluid level?

That transmission should have a dipstick behind the engine mount.
Forum: Vue Tech 12-17-2019, 11:22 PM
Replies: 3
Views: 242
Posted By bern
Re: 2008 Vue XE ABS Control Module

under the master cylinder area. Why do you want to replace it? The EBCM will need to be programmed to.
Forum: Vue Green Line 10-07-2019, 12:09 AM
Replies: 5
Views: 859
Posted By bern
Re: 2007 Saturn Vue Green Line (Hybrid) 12V battery not charging redux. Also, cut wi

The cut wires are from a recall back in 2008. The connector and harness that is connected to the starter generator is a replacement for the cut off wires during the recall. The belt is ok? You need...
Forum: Ion Tech 09-08-2019, 02:08 PM
Replies: 24
Views: 1,001
Posted By bern
Re: Sudden Leak

In the video it looks like your Ion has a manual transmission, does it? The oil drips on the trans maybe coming from the axle shaft seals and oil migrating forward to the lowest point.
The mess on...
Forum: Ion Tech 09-08-2019, 01:27 PM
Replies: 3
Views: 511
Posted By bern
Re: 2004 Saturn ion 2.2 manual transmission little to no clutch pedal

If the is still low then the clutch system still may have air in it.
Note most technicians don't know how to bleed these systems. did you share the information above with the technician (not the...
Forum: Vue General 09-02-2019, 03:51 PM
Replies: 2
Views: 216
Posted By bern
Re: Clicking/tapping by brakes

Th Ions had this problem on the right rear only. If the drum is machined too course. the cut in the drum would pull the shoes away from the backing plate the pop back in repeating. Check for too...
Forum: Ion Tech 08-18-2019, 07:14 PM
Replies: 3
Views: 511
Posted By bern
Re: 2004 Saturn ion 2.2 manual transmission little to no clutch pedal

You need to vacuum bleed the clutch. The vacuum needs to be pulled from the reservoir, leave bleeder screw closed. attach vacuum tool in way to the top of the reservoir that is air tight. pull the...
Forum: 2008 Vue 08-11-2019, 05:41 PM
Replies: 2
Views: 375
Posted By bern
Re: 2.4L Ecotec: Same camshaft position sensors?

it is not likely the sensors that are bad, but more likely the actuator control solenoids that bad. test for high resistance hot. check oil level. ACDELCO 12679100 and 12679099
Forum: Vue Tech 08-03-2019, 09:48 PM
Replies: 4
Views: 321
Posted By bern
Re: Cross bar loose on 2009 Vue.....

looks like an old window manual crank handle spline
Forum: Vue Tech 08-03-2019, 09:18 PM
Replies: 3
Views: 574
Posted By bern
Re: 06 Vue

The two wire circuits the go to the window motor are both by default connected to ground from the window switch, when the switch is pulled up the dark blue wire will be switch to positive power, when...
Forum: Vue Tech 07-21-2019, 12:44 AM
Replies: 2
Views: 534
Posted By bern
Re: 2006 Vue - driver's side rear door lock actuator removal

Get a new latch first. Then you break the old latch to get the door open. remove the weather strip from the inside back of the door opening. You may also need to remove the inside door trim panel....
Forum: Ion Tech 07-04-2019, 02:40 PM
Replies: 8
Views: 595
Posted By bern
Re: 2005 Saturn ION dies while driving and after its little colder it starts again

Is the check engine light on as it should be with the key on engine off? Does the engine crank after stall and while does not start?
Possible bad powertrain relay number 29 or other high...
Forum: Vue General 06-23-2019, 03:46 PM
Replies: 1
Views: 290
Posted By bern
Re: 2003 fob

The 2003 BCM was not very reliable, when the BCM failed replaced the new BCM was a improved design. The new design BCM is the same as the BCM in 2004-2007 Vues. The replacement BCM Kit include new...
Forum: Vue General 06-21-2019, 11:28 PM
Replies: 4
Views: 369
Posted By bern
Re: Alarm auto rearm

Auto arming and or auto locking Can be enabled or disabled while programming the BCM with SPS
Forum: Vue Tech 06-20-2019, 12:26 AM
Replies: 4
Views: 397
Posted By bern
Re: Hard miss, stall

You likely have a intermittent voltage drop on one of the battery cables.
Forum: Ion Tech 06-01-2019, 06:21 PM
Replies: 3
Views: 476
Posted By bern
Re: 2004 Saturn ion 3 Sedan manual trans

The DRL / turn signal circuit go though the BCM , The codes will need to be cleared in the BCM
Forum: Vue Tech 05-30-2019, 10:15 PM
Replies: 2
Views: 558
Posted By bern
Re: Window switches

Electrically it looks possible but I don't think the switch will fit on the other side . Even then it would only be auto down on the front windows
Forum: Vue Tech 05-30-2019, 09:59 PM
Replies: 4
Views: 401
Posted By bern
Re: Serpetine replacement on 08 3.5

Service information Shows Engine Mount bracket needs to be removed
Forum: Ion Tech 05-19-2019, 01:09 PM
Replies: 7
Views: 631
Posted By bern
Re: Impossible clutch bleed after replacing master cylinder
Forum: Ion Tech 05-16-2019, 12:10 AM
Replies: 6
Views: 528
Posted By bern
Re: 2003 Ion 3 alignment questions

The most recently hit left rear tire pushed trailing axle backwards. to adjust loosen the three large bolts that goes straight up underneath the left rear passenger door that holds the trailing axle...
Showing results 1 to 25 of 500

Forum Jump

All times are GMT -4. The time now is 01:33 PM.

Advanced Forum Search | Advanced Photo Search

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc. The Saturn Enthusiasts Site.