SaturnFans.com
what's new (beta) - classifieds - forums - photos


Go Back   SaturnFans.com Forums > Search Forums
Register FAQ Members List Groups Calendar Chat Room Search Today's Posts Mark Forums Read

Showing results 1 to 7 of 7
Search took 0.52 seconds.
Search: Posts Made By: 03ion_4life
Forum: Ion General 08-12-2017, 11:26 AM
Replies: 7
Views: 960
Posted By 03ion_4life
Re: Ion slave cylinder replacement...cradle removal section.

I evevetally got the hydrolic tube to seat properly in the slave, not sure what if anything I did differently. Doesn't pop out now.

other items to note. Switched over to silicone caulk for my oil...
Forum: Ion General 08-11-2017, 09:49 AM
Replies: 7
Views: 960
Posted By 03ion_4life
Re: Ion slave cylinder replacement...cradle removal section.

I put the mightyvac onto the slave bleeder and pumped it to about 5. I then moved the hydrolic line out a hair to get the fluid moving. I did release the vacuum and then reapply trying to pull more...
Forum: Ion General 08-09-2017, 07:28 PM
Replies: 7
Views: 960
Posted By 03ion_4life
Re: Ion slave cylinder replacement...cradle removal section.

This was a cap from a 5 qt oil jug. I drilled a hole and epoxied a hose just through the hole. The cap had a rubbery inner surface so it would seal to the master. Just start pumping the mightyvac and...
Forum: Ion General 08-09-2017, 07:07 PM
Replies: 7
Views: 960
Posted By 03ion_4life
Re: Ion slave cylinder replacement...cradle removal section.

I'll take a stab at answering my own question again.

My issue appears to have been with the pedal itself. After bleeding the slave I noticed the master rod moved itself out towards the pedal, but...
Forum: Ion General 08-07-2017, 09:12 PM
Replies: 7
Views: 960
Posted By 03ion_4life
Re: Ion slave cylinder replacement...cradle removal section.

On to more issues.

Bled the new slave actuator, pedal still goes to the floor with almost no resistance.

Air somewhere still? Broken master?

I tapped the the clutch for a bit, didn't seem...
Forum: Ion General 08-07-2017, 08:45 PM
Replies: 7
Views: 960
Posted By 03ion_4life
Re: Ion slave cylinder replacement...cradle removal section.

I'll answer my own question. Instructions on how I did it...

1) Disconnect battery cable in trunk– 8mm

2) Take lots of pictures before you start, just incase a something unexpected happens, or...
Forum: Ion General 07-23-2017, 09:13 PM
Replies: 7
Views: 960
Posted By 03ion_4life
Ion slave cylinder replacement...cradle removal section.

Anyone want to post the full instructions for getting at the slave cylinder on an 03 ion? Or a link to instructions that I can't seem to be able to find. I have some of the gm instructions from...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -5. The time now is 07:37 AM.

Advanced Forum Search | Advanced Photo Search


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
SaturnFans.com. The Saturn Enthusiasts Site.