SaturnFans.com Forums

SaturnFans.com Forums (http://www.saturnfans.com/forums/index.php)
-   Aura General (http://www.saturnfans.com/forums/forumdisplay.php?f=102)
-   -   07 Aura ECM changed won't start now (http://www.saturnfans.com/forums/showthread.php?t=232645)

TXViking 09-27-2017 02:02 PM

07 Aura ECM changed won't start now
 
I have a 07 Aura and had several issues going on at once, locks switching off/ on, rpms spiking and a few other issues. It also leaked oil right above the filter. I read on here about that but I'll change that after I fix the electrical issues.
I just changed the ecm and it has juice (radio comes on), but won't start. I ran a test and got p0315 code come up. This code didn't come up before. I got a code for a temp sensor. Need some advice on what to do next.

fdryer 09-27-2017 06:42 PM

Re: 07 Aura ECM changed won't start now
 
When anyone replaces ECMs, PCMs, BCMs where two electronic modules are married for the factory security program, a small can of worms is opened. Older Passlock security requires a 30 minute relearn (marry) procedure, easily done at home. GM uses their scantool and does it in 10 minutes. I don't know if Passkey (the RFID chip in key fobs) security requires the same marrying procedures when replacing modules. When ECM/PCM and BCM are replaced, the security password is learned (exchanged) otherwise the mismatched modules will not allow the engine to run.

The S-series and L-series models using Passlock require a relearn procedure when used modules are replaced. You'll have to search what procedures are needed and if this requires GM to perform or not.


All times are GMT -5. The time now is 05:00 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
SaturnFans.com. The Saturn Enthusiasts Site.