How To: Changing the Oil in a Saturn Outlook

Oil Filter for the Saturn Outlook

Here is a step-by-step how-to guide that I put together after changing the oil in my 2009 Saturn Outlook with GM's 3.6L Direct Injection (DI) V6. The procedure should also work for anyone with who owns a GMC Acadia, Buick Enclave, and Chevrolet Traverse. This process worked for me, but I cannot accept any responsibility for the procedure or provide any guarantees.

If you're not sure what to do at any given step, post a question or contact your local Saturn retailer!

Specifications:

  • Oil Filter: AC Delco PF-48
  • Oil Type: 5W-30
  • Oil Capacity: 5.5qt (includes oil filter volume)
  • Drain Plug torque: 18 ft-lb (216 in-lb)
  • Oil Filter torque: 18 ft-lb or as tight as possible by hand.

Instructions:

  • Drive front wheels on suitable ramps.

  • Place pan under the oil pan drain plug and loosen drain plug. Oil will shoot out approx 1ft rearward of drain plug so make sure to take this into account when positioning the pan.

  • Oil drain plug appears to be self tapping from the factory. Clean off plug threads to ensure there are no aluminum shavings before reinstalling.
  • Once oil has drained from pan, tighten the drain plug to 18 ft-lb (216 in-lb). This is an aluminum pan, so do not overtighten!
  • Locate oil filter. Remove oil fill cap and pop off the engine cover (just pull up on it). Replace oil fill cap for now.

  • Place oil pan under the filter area, but slightly towards the passenger side.
  • Using a strap type filter wrench (or any filter wrench that you prefer), reach down from the top and remove the filter. Some oil will pour out onto the engine mount. I put shop rags on the rubber portion of the mount to make things easier for cleaning up.

  • Wipe oil from engine mount (from top and bottom).

  • Apply some clean oil to the threads and seal of new oil filter (AC Delco PF-48 or equivalent) and fill approximately 1/3 with oil. I like as much oil in the filter as possible to help prime the system, but you're limited on how much you can put in since the filter is installed at nearly 90 degrees.

  • Hand tighten new oil filter as tightly as possible by hand. Do not use a wrench unless you plan to torque to the spec of 18 ft-lb (216 in-lb). I've always just installed them as tightly as possible by hand and never had an issue.
  • Use a funnel and fill with 5.5 qt of oil TOTAL (5.5qt is total system capacity with filter). Do not overfill.

  • Snap engine cover back in place.
  • Install Oil Fill cap. If you check oil dipstick at this point, it may appear over full since oil filter is empty (until you start engine). You need to start the engine, turn off, then check oil dipstick.
  • Start engine and check for any leaks while it's running.

  • Turn engine off and check oil dipstick.

Random Article from the SaturnFans.com Archives

General Motors Statement Regarding Black Oak Partners Press Release About Saturn

Tags:
GM Logo

As noted in GM's viability plan presented on February 17, 2009, GM announced it would review the potential spin-off or sale of Saturn and if those options did not prove viable Saturn's operations would be wound down over time. Over approximately the past 60 days, a sub-committee of Saturn retailers has been studying the feasibility of the sale or spin-off options, and has identified some parties that are potentially interested in a purchase or spin-off of Saturn. We are advised that one of the interested parties is Black Oak Partners. We are not at liberty to discuss any other interested party. With respect to what the eventual outcome concerning Saturn might be with Black Oak or any other interested party, it is simply premature at this time to speculate on what any eventual outcome may be.